Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Siqura Ex Fixed series
- Page 1 EX Fixed Series Ex d 316L Fixed camera station...
-
Page 2: Brand Names
Any brand names mentioned in this manual are registered trademarks of their respective owners. Liability Siqura accepts no liability for claims from third parties arising from improper use other than that stated in this manual. Although considerable care has been taken to ensure a correct and suitably comprehensive description of all relevant product components, this manual may nonetheless contain errors and inaccuracies. - Page 3 1.6 Dimensions......................10 Description The EX Fixed Series includes a full range of stainless steel fixed camera stations specifically designed for Hazardous Area applications. The design of the housings ensures the best protection from external agents along with easy installation and maintenance service. EX Fixed camera stations are equipped with the latest generation zoom module day/night and thermal imaging cameras.
- Page 4 EX Fixed Series - Installation Manual This product is designed for use with flammable gases and vapours covered by apparatus groups IIA, IIB and IIC with temperature classes T1 to T6 and with flammable dust covered by apparatus groups IIIA, IIIB and IIIC with temperature T=85 °C. The surface temperature class of the device was determined only with ambient air temperature, without taking into consideration direct sunlight.
-
Page 5: Install The Unit
EX Fixed Series - Installation Manual Install the unit ● Any action performed on the unit which is not described in this manual may damage it. ● Make sure that the installation surface can support at least four times the weight of the unit in normal operating conditions. - Page 6 EX Fixed Series - Installation Manual ● To maintain the certification requirements and the IP rating of the unit, adequate certified cable glands must be used. Each unused cable gland hole must be closed using a proper plug suitable for the housing marking.
- Page 7 EX Fixed Series - Installation Manual 3. Connect cabling Feed the cables through the rear cable glands. Perform the electrical connections on the board. Supply voltage: - 24 Vac supply voltage (on "LINE" connector: line on L pin and neutral on N pin).
- Page 8 EX Fixed Series - Installation Manual 6. Attach sunshield ● Attach the sunshield to the housing using the screw and the spacer provided in the kit according to the image. 7. Install the nozzle ● Attach the nozzle at the front of the camera, right below the sunshield.
-
Page 9: Technical Data
Any repair or part replacement must be done by, or under supervision of, Siqura. Use only original spare parts. The manufacturer declines all liability for any damage resulting from tampering, use of non-original spare parts and service carried out without following the directives of the present manual. - Page 10 EX Fixed Series - Installation Manual Certifications Weatherproof standard IP66/IP67 Rating II 2 G Ex db op pr IIC T6 Gb Tamb -40 °C to +60 °C II 2 D Ex tb IIIC T85°C Db IP66/IP67 ATEX Standards EN 60079-0:2012; EN 60079-1:2014;...
- Page 11 EX Fixed Series - Installation Manual MOUNTING PATTERN Dimensions in millimetres - Tolerances according to QMS - Design and product specifications subject to change without notice Every unit must carry a marking plate similar to the one on the right...
- Page 12 Appendix: RS-485 Address The analogue camera inside EX-BC36 and SA-BC36 camera stations (fixed and PTZ models) can be controlled from a PC with an RS-485 converter using a suitable program (Hyper Terminal, for example). In This Chapter Set the unit address (fixed camera)................12 Presets........................
- Page 13 Appendix: RS-485 Address Camera board layout Conn. Description Layout 24 V~ AUX 1 24 V~ wiper out AUX 1 24 V~ wiper common AUX 2 24 V~ washer out AUX 2 24 V~ washer common A+ Tx B- Rx Item Description Remarks 24 Vac power input...
Need help?
Do you have a question about the Ex Fixed series and is the answer not in the manual?
Questions and answers