Important Safeguards - Chef's Choice SmartKettle 686 Manual

IMportant SafEguardS

When using electrical appliances, basic safety precautions should always be followed,
including the following:
1. Read all instructions carefully.
2. Do not touch hot surfaces. Always lift by handle.
3. To protect against fire, electric shock and injury to persons, do not immerse cord, plug, SmartKettle
or power base in water or other liquid.
4. Close adult supervision is necessary when any appliance is used by or near children, handicapped
persons or the infirm.
5. Always unplug the power base when not in use in order to avoid accidental electrical shock.
Allow SmartKettle
®
6. Do not operate with a damaged cord, or plug, or after a malfunction has occurred or the kettle has been
damaged in any manner. Return SmartKettle
examination, repair or adjustment.
7. The use of accessory attachments not recommended by the EdgeCraft Corporation may result in fire,
electric shock or injury to persons.
8. Do not use SmartKettle
9. Do not let power cord hang over edge of table or counter or touch hot surfaces.
10. Do not use this SmartKettle
11. Do not attempt to plug any device other than designated SmartKettle
12. Do not place on or near hot gas or electric burner or in a heated oven.
13. Do not operate SmartKettle
14. Never fill SmartKettle
15. Do not turn on the Heat to the SmartKettle
16. CAUTION: Unplug IMMEDIATELY if water spills onto bottom of SmartKettle
connector, to avoid electrical shock.
17. CAUTION: To avoid the risk of being scalded never fill SmartKettle
the water level gauge. For the same reason, extreme caution must be used when moving an appliance
containing hot water or other hot liquids. Always pour slowly and carefully.
18. Only operate SmartKettle
19. Scalding may occur if the lid is removed during the brewing cycles.
20. For household use only.
SavE thESE InStruCtIonS
to cool before cleaning.
outdoors.
®
or the power base for other than intended use.
®
unless lid is fully closed.
®
while it rests on the power base.
®
®
on a dry, flat, non-slip surface.
®
to the EdgeCraft Corporation, Service Department for
®
unless there is sufficient water.
®
2
into the power base.
®
, onto power base or into
®
above the "MAX" line shown on
®