YachtSafe W010 Manual

Manual
W010 Remote control
1. Connect with the alarm by using the Smartphone app
Make sure that you have downloaded the latest version of the app. The
alarm unit needs to be connected to a voltage source while
2. Mounting
The main function of the remote control is to turn on and o the GPS-
alarm.There is also a SOS button that activates an alert message with
position information which is sent to the prede ned alarm numbers.
It's also possible to put the alarm unit in a low power consumption
mode or control power of an external device, e.g. a heater or fridge in
a boat. The communication between the remote control and the alarm
unit is bidirectional. When the remote is ashing, it means that the
command is sent and the alarm unit has received the key press. One or
several remote controls can be used for the same alarm unit.
Activate the alarm for theft and burglary.
Inactivate the alarm for theft and burglary.
Send a text message with the position
of the alarmunit by holding the
button down for three seconds.
This button has two di erent functions.
– By pressing the button you can turn on or o the power of an external device, e.g. a heater or fridge if this is chosen.
– To switch to the low power consumption mode you hold down the button for about 10 seconds until the LED-light is ashing
once. You also receive a text message with status information to your prede ned alarm numbers. To switch back you just
hold down the button again for about 10 seconds until the light is ashing.
Version 01 l VETEL AB l info@vetel.se l www.yachtsafe.se l Göteborg l Sverige
pairing.
iPhone
1. Click on Accessories at the bottom right of the start
page. Choose then Accessories settings.
2. Click on the plus button at the top right of the page.
3. Click on the accessory you want to connect. Later
choose Connect
Go to the status page for the accessories to activate the sensors
of the accessories. The installation is now done.
*The little LED-light on the accessory starts ashing
fast if the connection to the alarm is ok. If the attempt
to connec fails the light is lighting up for 1-2 seconds.
If you don't receive any feedback please try again.
Android
1. Click on the menu button at the bottom of the Android
phone to see the box of alternatives. Choose later Accessory
Setting.
2. Click on Choose accessory under Connect new accessory.
3. Click on the accessory you want to connect. Later choose
*
Connect
Go to the status page for the accessories to activate the sensors
of the accessories. The installation is now done.
Technical speci cation
Measurements:
Battery lifetime:
Type of battery:
Battery capacity:
Distance range (free sight):
Temperature range:
Sealing:
*
and follow the instructions.
and follow the instructions.
wireless alarm and control solutions
EN
58 x 30 x 11 mm
up to 3 years
CR1632
130 mAh
ca 100 m
-30 to 70 °C
IP54
R