Advertisement
Dust Shroud For Gas
High Speed Saws
DustBull D1763 fits Husqvarna
DustBull D1764 fits STIHL
DustBull D1765 fits Makita
And Fits many more saws!
OWNERS MANUAL
gas highspeed saws
®
gas highspeed saws
®
gas highspeed saws
®
Stops
Dust
Storms!
LIVE CUSTOMER SUPPORT & SERVICES:
1.800.568.3949 Toll-free in the U.S.
dustlesstools.com
PATENT NO. 8137165
Advertisement
Table of Contents
Summary of Contents for DustBull D1765
- Page 1 DustBull D1763 fits Husqvarna gas highspeed saws ® DustBull D1764 fits STIHL gas highspeed saws ® DustBull D1765 fits Makita gas highspeed saws ® And Fits many more saws! LIVE CUSTOMER SUPPORT & SERVICES: 1.800.568.3949 Toll-free in the U.S. dustlesstools.com...
- Page 2 Installation instructions for the STIHL Gas Saw 4. Place gas saw on top of the DustBull and SETUP install 6” bolt through the holes (Circle) of the front bracket and the holes in the top 1. Loosen and remove the 2 screws of the DustBull.
- Page 3 DustBull. Rear Bracket 3. Install the rear mounting bracket to the back end of the DustBull. On the tube of the DustBull, remove the two screws and magnet plate. Set the mounting bracket on the DustBull over the two screw holes and reinstall the screws and tighten till secure.
- Page 4 Installation instructions for the Husqvarna Gas Saw 4. Install the DustBull to your Husqvarna gas SETUP saw by lining up the holes in the bell of the DustBull with the holes on the front 1. Remove screws from the bottom front end bracket.
Need help?
Do you have a question about the D1765 and is the answer not in the manual?
Questions and answers