Falcon Waterfree C1M2PLUS Maintenance

URINAL BOWL

CLEANING INSTRUCTIONS

1
Spray (mist) cleaner on the entire bowl.

WHEN SHOULD A CARTRIDGE BE CHANGED?

Blue sealant appears on top of the cartridge
C1M2+ CARTRIDGE
1
Insert key into cartridge.
CAUTION
After removing cartridge
from housing, certain naturally
occurring but potentially hazardous
sewer gases may escape through the
opening until re-installed properly. If
replacement cartridge will not be re-
installed immediately, place a rag or
paper towels into opening to block any sewer gases. Remove
the paper towels or rag prior to inserting new cartridge.
Alternatively, use Falcon Foam Housing Cleaner to both clean
housing during cartridge change. Never smoke, have an
urinal housings into which a cartridge is not yet properly
installed. You also can wear a breathing mask when removing or
installing any waterless urinal or cartridge to reduce potential
exposure to any such gases.
8
Insert new cartridge into housing and
turn key to right to lock and click into
place.
2255 Barry Ave. Los Angeles, CA 90064 | Tel 310.209.7250 | FalconWaterfree.com
2
Clean outside and inside of bowl with rag, sponge, or mop.
OR

CHANGING INSTRUCTIONS

2
Turn key to left to unlock.
5
H1
Scrub the housing and deep inside of the tailpipe
with a long 1.5-inch diameter nylon brush.
9
liter) or more of clean water until
there are no air bubbles.

MAINTENANCE

OR
OR
Fluid does not drain into the cartridge
3
Lift and tilt cartridge to drain all free liquids then
spray Falcon Foam Housing Cleaner into housing.
6
H3
Flush housing with 5
gallons (20 liters) of hot
soapy water.
10
Add blue sealant (allow time to drain
into cartridge).
4
Place cartridge into bag, tie
bag to seal and dispose.
7
Wipe clean inner stainless
steel rim.
1 1
Spray (mist) bowl with cleaner and
wipe clean.