Myron & Davis RSS201 User Manual

Parking sensor system

Advertisement

RSS201
PARKING SENSOR SYSTEM
USER'S
MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RSS201 and is the answer not in the manual?

Questions and answers

Summary of Contents for Myron & Davis RSS201

  • Page 1 RSS201 PARKING SENSOR SYSTEM USER’S MANUAL...
  • Page 2: Led Digital Display

    GENERAL INSTALLATION DIAGRAM LED DIGITAL DISPLAY While reversing, the displaying mode is: Display 1.5m Safe area Green Control box 1.3~1.4m Safe area Green 1.0~1.2m Safe area Green 0.7~0.9m Alarm area Yellow 0.4~0.6m Alarm area Yellow 0.3m Danger area <0.3m Danger area White wire —...
  • Page 3 Internal adhesive installation Safe rea Alarm Area 0.6-0.8m 0.3-0.4m Best position for 2 sensors Best position for sensors Directions of sensors 1 Alarm Area Internal Internal Danger Area External Directions of sensors 1 Danger Area SENSOR INSTALLATION DIAGRAM Slopng installation position to the ground Vertical installation position to the ground External adhesive installation Various internal &...
  • Page 4: Installation Tools

    INSTALLATION TOOLS 2.SELECT DRILLING POSITION FOR A & D A.Choose suitable drilling position for A & D sensor with relevant mark B.To perform the best detecting angle, select the position for A & D sensor with 8 - 13cm away from the side, 11cm is suggested 3.SELECT DRILLING POSITION FOR SENSOR B &...
  • Page 5: Parking Sensor

    H-101 PARKING SENSOR SENSOR INSTALLATION H-101 parking system consists of ultrasonic sensors, digital control box and LED display. This system detects the distance between the car and rear obstruction by ultrasonic sen- A.sensor with metal slice must sors installed at the rear bumper of car. The distance will be displayed in an innovative mode be up &...
  • Page 6: Alarm Mode

    3. Switch D5 used to choose Turn NO/OFF of the initial indication tone INSTALLATION AND TEST Switch D System corresponding function system enterring into reversing,no indication tone 1. Adjust the directions of the sensor and the axial orientation, neaten the wire after sensor installation control box system enterring into reversing mode, the buzzer beep 2 times to 2.

Table of Contents