Universal Furniture Explore Home 994-638 Instruction Sheet

932/994/995/996-638
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.

PARTS LIST:

# Description
A Chair Back and Seat Frame Assembly
C Back Leg
E Slip Cover
Assembly Procedure:
CAUTION: PLEASE DO NOT OVER-TIGHTEN BOLTS DURING ASSEMBLY.
NOTE: FIRST READ THE CHAIR LEVELING INSTRUCTIONS, THIS IS AN ADDITIONAL
ASSEMBLY INSTRUCTION SHEET FOUND INSIDE THE CARTON.
Step 1: Place all chair parts on a soft and smooth surface.
Step 2: Attach Front Leg (B) and Back Leg (C) to the bottom of Chair Back and Seat Frame
Assembly (A) as shown in Step 1 & 2. The back legs are marked Left & Right.
Tighten all bolts securely. Caution: Do not over tighten bolts.
Step 3: Turn the assembly chair to upright position.
Step 4: Level the chair following "CHAIR LEVELING INSTRUCTION" This is an additional assembly
instruction sheet found inside the carton.
Step 5: Make sure the chair is level and tighten all bolts completely using the wrench supplied.
Step 6: Cover the chair with the provided Slip Cover (E) and place the Upholstery Pad (D) on the
seat.
Assembly is now complete.
INSTRUCTION SHEET
Qty.
1pc
2pcs
1pc
UPHOLSTERED SIDE CHAIR
# Description
B Front Leg
D Upholstery Pad
Qty.
2pcs
1pc