Autostyle Parksafe PS440 Installation Quick Manual

PARKSAFE AUTOMOTIVE LIMITED
PARKING SENSOR INSTALLATION QUICK GUIDE

GENERAL INFORMATION.

COLOURS - Matt Black, Gloss Black, Silver, White. Factory colour coding by request.
DIP SWITCH - Switch 1, Anti-hook function. Prevents alarming on tow hitch or spare wheel.
The first 20cm of the sensor beam is ignored from the bumper outwards. (Not available on
PS440)
Switch 2, Detection range of sensor A & D adjustment. (Reduced to 1m from 2m) (Not
available on PS440).
Sensor height. Mount sensors ideally at a height no lower than 0.5m. If lower use PS740
sensors and collars and/or LOW/HIGH adjustment.
LOW/HIGH - Adjusts the sensor beam height by +/- 10cm.

BUMPER STYLE

PS440-540
Flat plastic bumper only
PS740
Curved plastic bumper (Collars included)
PS940
OEM Look, plastic bumper only
PS1940-16
Metal and plastic bumpers
PS1040-16
Under-hung sensors

METAL BUMPERS

For metal bumpers it is recommended to use rubber
sensors or under-hung sensors.

SELF PAINTING

Do not apply the paint too thick as it may effect the
performance. Always prime first.

CONTROL BOX

The control box is not waterproof, please mount it in
a clean dry area (Wireless system control box is
waterproof)

DISPLAYS

All kits apart from the PS440 can use a display

WIRELESS PARKING SENSOR KIT

Installation is the same however the Control box and
Display unit require their own power supply the control
box takes power from the reversing light positive and
ground. The display can take power from the vehicle.

PSPK1 CAN INTERFACE

If using PSPK1 CAN interface connect yellow wire to
the purple wire on the PSPK1 this will then activate the
sensors below 6mph. If the customer wants to disable
the sensors add a rocker switch between the yellow
and purple.