Advertisement
Quick Links
Advertisement
Summary of Contents for Sintai Optical 1DX
- Page 1 WLAN+BLE Module MODEL ＮＯ:１ＤＸ Quick Installation Guide...
- Page 2 Installation steps WLAN 1. First, install Murara Wireless+BLE combo Driver of EVM Board. 2. Make "RCT" folder in a root directory of the micro SD card. 3. Make "WlanTest.txt" file in the RCT folder. (WLAN continuous transmission/receiving mode) 4. Insert MICRO SD CARD into EVM Board 5.
- Page 3 II. DC/RF Characteristics Supply Voltage Storage Temperature -40~+85 degree C DC 3.3V from host Supply Voltage VDDIO DC 3.3V from host DC/RF Characteristics for IEEE802.11 b/g/n Specification IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, DSSS/CCK：up to, OFDM：up to 54Mbps OFDM：up to 65Mbps Data rate 11Mbps Output Power...
- Page 4 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
- Page 5 This device is intended only for OEM integrators under the following conditions: 1) The transmitter module may not be co-located with any other transmitter or antenna. As long as 1 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed IMPORTANT NOTE: In the event that these conditions can not be met (for example...
-
Page 6: Industry Canada Statement
Industry Canada statement: This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’... -
Page 7: Note Importante
Le manuel de l'utilisateur final doit inclure toutes les informations réglementaires requises et avertissements comme indiqué dans ce manuel. This radio transmitter (IC: 11195A- 1DX / Model: 1DX) has been approved by ISED to operate with the antenna type listed below with maximum permissible gain indicated. - Page 8 Le présent émetteur radio (IC: 11195A- 1DX / Model: 1DX) a été approuvé par ISED pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.
Need help?
Do you have a question about the 1DX and is the answer not in the manual?
Questions and answers