Do you have a question about the Aqua and is the answer not in the manual?
Questions and answers
Summary of Contents for Dreamline Aqua
Page 1
AQUA HOWER NSTALLATION NSTRUCTIONS IMPORTANT DreamLine reserves the right to alter, modify or redesign products at any time without prior notice. For the latest up-to-date technical drawings, manuals or any other details please refer to the support.BathAuthority.com web page. Please carefully read the instructions before installing. If you have any questions regarding installation, please call our technical support specialists Monday through Friday 9:00 AM –...
Page 2
Building and plumbing codes may vary by location, and DreamLine is not responsible for code compliance standards for your project. 4. Please insure that prior to the installation the installation surface is leveled and solid and will be able to support the total weight of the unit.
Before discarding the carton, check for small hardware bags that tend to fall to the bottom of the box. If any parts are damaged or missing, please contact DreamLine for replacement.
Page 4
Shower/Tub Door Installation 1. Place the Wall profile (External) (01a) to the wall above the Shower base or Tub and level it vertically. See Fig. 1 for details. 2. Mark the drilling holes on the wall through the holes in the Wall profile (External) (01a).
Page 5
3. Push U-Shape seal gasket (13) over the vertical edge of the Stationary glass (02). Place the Stationary glass with attached U-Shape seal gasket onto the Shower base and slide it into the Wall profile (External) (01a). Attach the Wall profile (Internal) (01b) to the Wall profile (External) and the Stationary glass using Countersunk...
Page 6
4. Take apart the Bottom bracket (14), place the mounting part into the U shape hole on the Stationary glass (02) from inside and mark the drill hole on the threshold, tray or bathtub. Remove the glass, drill the hole using Ø1/8”...
Page 7
6. Mark the hole for the Support bar (03) on the wall according to the measurements. See Fig. 8 for details. Rev 2.2...
Page 8
7. Drill the hole in the wall using Ø5/16” drill bit and insert Wall anchor (07). Remove the bracket from Support bar (03) and attach it to the wall with Round head screw ST4.2×30(10). Ø5/16" See Fig. 9 for details. 8.
Page 9
. 11 9. Install the Hinges (04) on the Stationary glass (02) with the decorative non-screw side facing outwards. Hang the Glass door (05) from the inside. You will need assistance in this process. NOTE: Use clear rubber gasket to prevent glass to metal connection.
Page 10
. 13 10. Install the Handle (06) onto the Glass door (05). Attach the Connected anti- water strip (11) over the vertical edges of the Glass door and the Stationary. Push the Bottom anti-water strip (12) to the glass door. Attach the Bottom anti-water strip (12) over the bottom edge of the Glass door.
11. Apply caulk inside and outside along bottom vertical edge stationary glass and wall profile. See Fig. 15 for details. CAULK . 15 Product maintenance To insure long lasting life for your acrylic back walls, wipe them off after each use with a soft cloth. To clean the acrylic back walls use non-abrasive sprays or cream based cleaners.
Any product replaced or repaired during the warranty period will be covered only for the remaining period of the original warranty. In no event will DreamLine be liable for costs of repair or replacement of any installation material, including but not limited to tiles, marble, etc.
Page 13
TEL: 866-731-8378 – 215-957-1411 FAX: 866-227-9245 – 215-893-1780 WWW. UTHORITY.COM For more information on DreamLine Shower Door Tub Door please visit www.BathAuthority.com Rev 2.2...
Need help?
Do you have a question about the Aqua and is the answer not in the manual?
Questions and answers