Razor POCKET ROCKET Installation Manual page 2

Step 4: Reconnect the wire connections
Reconnect all plug-in connections (see Figure 4a).
Each connection point is unique, so the system can
only be connected in one way: the right way.
Note: If your existing controller has a 6-pin connector (see
Figure 4b), the replacement controller will require use of the
supplied adapter.
Figure 4a
Step 1: Remove the old bolts
Using the supplied 5mm Allen wrench, remove
and discard the old bolts (see Figure 1a).
Need Help? Visit our website for additional video instructions at www.razor.com or call toll-free at 866-467-2967 Monday - Friday
8:00am - 5:00pm Pacifi c Time.
Figure 4b
Figure 1a
Step 5: Secure the new controller
Secure the new controller in place and tighten the
mounting screws (see Figure 5). Reattach plastic
cover to frame (see Figure 1a).
HANDLEBAR BOLT REPLACEMENT
Step 2: Install the new bolts
Using the same 5mm Allen wrench, screw in the
new bolts with a washer and a lock washer (see
Figure 1b).
Figure 5
POCKET ROCKET™
Figure 1b
2