Page 2
U.S. and International patents. Patent info: www.edgeforlife.com/patents. These intellectual property rights (IPR’s) remain the exclusive property of Edge Systems or its licensors. This product sold is subject to a license to use the IPRs only in conjunction with original Edge Systems products.
BEFORE YOU START Introduction Safety Information GETTING STARTED Packaging & Unpacking Inspection Setup - Waste Canister - Tubing 11 OPERATING INSTRUCTIONS Turn on the System Standby/Sleep Mode Touchscreen Operation Skin Solution Vials 13 SYSTEM CLEANING & PREVENTIVE MAINTENANCE After Each Service 14 TROUBLESHOOTING Touchscreen Wear and Tear Items...
Before You Start INTRODUCTION Congratulations on purchasing Perk™, the next generation of skincare. As the world’s first hybrid facial, the Perk™ system: Loosens dirt, oil and dead skin cells from the surface of skin through operator-controlled › gentle exfoliation. Cleanses the skin by flushing and suctioning away those impurities.
Before You Start STANDARDS TO WHICH CONFORMITY IS DECLARED: SAFETY: IEC 60335-2-23:2003 used in conjunction with IEC 60335-1:2001+A1:2004 EN 60335-2-23:2003 used in conjunction with 60335-1:2002 EMC: EN 61000-6-3:2007+A1:2011 EN 61000-6-1:2007 SAFETY INFORMATION PRODUCT MARKING SYMBOLS SYMBOL DESCRIPTION Attention: Refer to accompanying documentation. Aufmerksamkeit: Beziehen Sie sich begleitend auf Dokumentation.
Edge Systems. Be sure to read the User Guide thoroughly before setting up the system. If you experience mechanical and/or electrical difficulties with your unit, call Edge Systems Service Department at 1-562-597-0102. P E R K...
Page 7
Before You Start SAFETY GUIDELINES (CONTINUED) Always use a clean vial tip included with each vial kit for each procedure. The Perk tips are ™ for single use only, per individual. Use for more than one procedure may result in cross contamination.
Page 8
Edge Systems LLC. Equipment returned to Edge Systems LLC with unsafe modifications will be returned to their original operating condition at the customer’s expense.
Page 9
Any external cleaning should be done with a clean, dry or slightly damp cloth. Any replacement cables and parts should be acquired directly from Edge Systems LLC. Elektroschock zu verhindern, nimmt die Instrumentdecke nicht heraus. Es gibt keine vom Benutzer haltbaren Teile hinein.
Page 10
Tout nettoyage externe doit être fait avec un chiff on propre, sec ou légèrement humide. Tout câble et toute pièce de rechange doivent être achetés directement auprès d’Edge Systems LLC. All electronic repairs and computer battery replacements should not be CAUTION: attempted by user, but referred back to Edge Service Department.
If you see visible damage, make a claim with the carrier immediately. If the equipment is damaged, notify Edge Systems at (800) 603- 4996 or (562) 597-0102 and we will assist you in the repair or replacement of your equipment.
You can only use the power cord supplied with NOTE: your unit. Contact Edge Systems Service Department at 1-562-597-0102 if you encounter any issues with the power supply. If the power cord is plugged into the top power entry port, press the switch to the ( ) icon to turn on the unit.
™ will be displayed. To go to the Main Menu, press the screen with your fingertip. The Main Menu will have three options: the Perk ™ option button, the Cleaning Mode option button, and the Settings option button. To select an option, press the button.
System Cleaning Solution bottle cap. Note: Only use Edge Systems Cleaning Solution. It is specifically developed to flush through the tubing line to remove and prevent any product or impurity build-up.
TUBING: EXTERIOR To clean the exterior of the Perk Module, use a clean cloth dampened with water to wipe off stains or residue. Note: Do not use any detergent or abrasive media or cleaners as this may remove the exterior paint.
Page 17
Switch Ensure that the switch is pressed in the correct direction No image Call your local representative or Edge Systems. TOUCHSCREEN Screen does not respond Call your local representative or Edge Systems. to touch Empty vial Make sure Skin Solution Vial is not empty.
This limited warranty applies and extends only to the original Customer purchasing the System from Edge Systems in the country where the sale occurred. This limited warranty is non-transferable and non- assignable by the original Customer. Edge Systems shall have no obligations underthis limited warranty in the event that an original Customer attempts an unpermitted assignment of the original Customer’s...
Page 19
Edge Systems can be reached by telephone (toll free) at 1-800-603-4996. The Customer is responsible for all arrangements and shipping charges (incoming and outgoing) related to the shipment of a System or parts to an Edge Systems approved and designated repair facility for inspection and diagnosis for potential coverage under this warranty.
CLIENT CONSULTATION & RELEASE FORM Please read carefully, complete, sign and date this form prior to your treatment. NAME: PHONE ( ADDRESS CITY STATE SECTION 1: MEDICAL INFORMATION DO YOU HAVE ANY OF THE FOLLOWING CONDITIONS? Shellfish Aspirin Sulfur Preservatives Other (Please List): YES NO Accutane or other similar medication...
Page 21
DO YOU HAVE ANY OF THE FOLLOWING CONDITIONS? (CONTINUED) YES NO Laser procedures, chemical peels, dermabrasion, microdermabrasion Light sensitive medication Loose, thin, aged skin Lymphatic disorder, inflammation of lymph vessels, lymphedema Medication, list here: Open Lesion/Wound Phlebitis, varicose veins Recent accident or serious injury Recent surgical or dental procedure Rosacea, telangiectasia/couperose Retin-A, Retinol...
I acknowledge that I have answered all questions truthfully and completely. _____(initial here) I release Edge Systems, the ______________ (Aesthetician/Doctor), management and staff of _______________ (Clinic/Office) from any and all liability associated with any injuries and/or current or future conditions resulting from the skincare procedures or products._____(initial here)
Page 23
Appendix I: Client Questionnaire & Consent Form This page is intentionally left blank P E R K User Manual...
Page 24
EDGE SYSTEMS LLC 2277 Redondo Avenue, Signal Hill, CA 90755 USA Tel. (800) 603-4996 (562) 597-0102 | Fax. (562) 597-0148...
Need help?
Do you have a question about the Perk and is the answer not in the manual?
Questions and answers