Caster Attachments; Lectro-Stack - LectroTruck LTA6512 Owner's Manual

Caster Attachments

Original Caster Attachment - The original caster attachment allows the operator to swivel loads in tight
spots and to make turns on small landings in the vertical position.
To mount the Caster Attachment, place the flat head rivet found on the top side of the Caster
Attachment in the hole in the Toe Plate. Slide the rivet head into the slot on the Toe Plate to secure it.
Place the hook on the short piece of strapping in the slot on the front of the Caster Attachment and the
hook on the long piece of strapping to the top of the inner frame. Then fasten the two straps together
and pull until tight. This will hold the caster attachment to the bottom of the load.
CAUTION: Be sure that the strap is hooked to the Inner Frame, not the Outer Frame.
New Style Caster Attachment - The new style caster attachment is slightly different than the original in
that it only involves one set of caster wheels (below, left). The user installs the caster attachment to the
front of the load. When the load is placed in an upright position, the load is supported by two caster
wheels and the 8"x 2" wheels of the Lectro-Truck (below, right).

Lectro-Stack

The Lectro-Stack stacker attachment allows the user to be able to vertically lift objects that weigh up to
750 pounds - up to almost 5 feet. The Lectro-Stack can be used as a stand-alone piece, as it has it's
own battery and powered winch; or it can be used as an accessory to the Lectro-Truck.
Attaching the Lectro-Stack to the Lectro-Truck
1. Position the Lectro-Stack so the wheels are centered on the toe plate of the Lectro-Truck.
2. Locate the proper "eyelets" to use on the rear of the Lectro-Stack to feed your straps through. (See
chart below.)
Model Eyelets to Use
LTA6512 A & D
LTA5512 A & D
LTA4512 C & D
1268E B & D
1260E B & D
3. Position your strap bars according to the height of the eyelets,
feed your strap through both eyelets, and tighten into place.
The strapping that you have on your Lectro-Truck
will work to attach the Lectro-Stack. However, the
NOTE
straps that work the best are ratchet straps that can
be ordered for your Lectro-Truck.
4. Position your load to be moved onto the forks of the
Lectro-Stack. You are now able to position your load as high as
you need to make moving low, heavy objects easy to move. The
operation of the Lectro-Truck is the same as described on Page 14.
Lectro-Truck Owner's Manual
Eyelets
A
B
C
D
Page 22