TO BE REMOVED FOR USE BY OCCUPANT
Swan
C O R P O R A T I O N
Drain Assembly
Figure 1
Read ALL instructions carefully BEFORE starting your installation
1. Measure and cut counter hole for sink insertion 23-5/8" wide x
20-5/8" long. Test fit sink. File any areas which require widening.
2. After test fitting sink, remove from counter hole and install faucet
(not included) and drain assembly (see Figure 1).
Helpful Hint .... for easy installation of final supply line
connections, it is suggested that, if possible, plumbing
connection to faucet be made at this point. Plumbing
connections to hot and cold supply line can then be made after
sink is secured to counter top.
3.
In the installation of the SSUS1000, DO NOT use the white washer
in the installation process. Use of the white washer may cause the
drain to sit improperly and cause water to pool around the drain
area.
Installation Procedure for
MODEL SSUS1000
SWANSTONE UTILITY SINK
12 1/4"
CAPACITY 17.50 GALLONS
4. Set sink into place and assemble bracket, washer, and nut
5. Some caulking residue may flow from under sink flange. This
6. Attach drain waste and faucet plumbing.
Mounting Assembly Figure 2
Mounting Point
Clip
Threaded Bolt
attachments (see Figure 2). Alternating from one to another,
tighten mounting bracket assembly nuts.
residue can be wiped clean following instructions on silicone or
latex caulking tube.
3 3/4"
FORM #651-6-15-1M