Advertisement
General Information
Thanks for purchasing Vision's Wireless Rear View Camera System. Vision's VAE 738
wireless rear view camera system is not only able to enhance your driving experience but
also is designed to reduce the risk of collisions and other potential harm when the vehicle
is reversing.
VAE-738 is using 2.4GHz digital transmission technology to transfer the rear view to your
monitor when backing-up. Meanwhile, the system supports multi-channel which tune
automatically to avoid the signal interference.
Declaration:
Vision's Wireless Rear View Camera System does not guarantee or promise that the user
will not be in an accident or otherwise not collide with an object. Vision's Wireless Rear
View Camera System is not intended for use as a substitute for rear-view mirror or for any
other motor vehicle equipment required to be installed by law.
Package Contents
VAE 738 Wireless Rear View Camera System includes:
1PC * Transmitter
1PC * Receiver
1PC* Installation & Operation Manual
1Pack* Fitting Kit
Specification
Video system: NTSC/PAL (Auto detection)
Video input: 1.0 Vp-p 75Ω
Voltage: 9-32Vdc input
Current consumption TX: ≦300+/-20mA @ 12V
Current consumption RX: ≦200+/-20mA @12V
Digital Transmission: 2.4 GHz, SST 20 channel (FCC/CE)
Dimensions: 113.7(w) x 114.3(h) x 30.8(d) mm
Environmental TX: IP69
Environmental RX: No IP rating
Operating temp: -40℃~+85℃(-40 ℉~+185 ℉)
Wiring Diagram
-1-
-1-
1. RCA (Yellow) : Camera video connection
2. Red Wire: Power (Connect to reverse signal 12/24Vdc)
3. Black: wire Ground
4. Black/Red wire: Power supply for camera (optional)
1. RCA (Yellow): Video out
2. Red Button: Pairing function button
3. Black Wire: Ground
4. Red Wire: Power (Connect to Reverse signal 12/24VDC)
Installation
Please read the instruction thoroughly prior to installation. Improper installation will void
manufacturer's warranty. Please note that this package does not include monitor and
camera. Follow the wiring diagram to complete all connection setup. Equipping RX
receiver under dashboard with four screws and fixing TX transmitter in the end of trunk
with four screws as well. When gear is put in reverse position, the transmitter will
automatically power on.
Operation
When gear is in reverse position, monitor display rear view automatically which help
drivers identify an object or a person behind a car and prevent damages from unwanted
accidents.
-2-
Advertisement
