Boss MSC13171 Installation Instructions

WARNING
CALIFORNIA
Proposition 65 Warning
WARNING: The power cord on this product
contains lead, a chemical known to the State
of California to cause birth defects or other
reproductive harm. Wash hands after handling.
Installation
DANGER
Vehicle engines contain moving parts and can
become extremely hot, capable of causing severe
burns and serious bodily harm.
Shut off the engine and allow it sufficient time to
cool down before installing this kit.
DANGER
Vehicle batteries can cause dangerous electrical
shocks that could lead to severe burns or death.
Disconnect your battery before installing this kit.
Note: Apply dielectric grease to all electrical connections.
1. Connect the white/black wire from the wire harness to
the small post on the pump solenoid
© 2016—BOSS Products
P.O. Box 787
Iron Mountain, MI 49801
Power/Ground Extension Kit
Part No. MSC13171
(Figure 1).
Register at www.bossplow.com.
Safety
•
Always follow the vehicle manufacturer's
recommendations relating to system installation.
•
Due to the variety of equipment that can be installed using
the undercarriage, ensure that the gross-vehicle-weight
rating (GVWR) is not exceeded at any time. You may
need to weigh the vehicle and add ballast or limit the
payload of the vehicle to compensate.
1. Red fused wire
2. Long battery extension
cable
3. Red power/ground cable
2. Connect the brown wire from the wire harness to the
other small post on the pump solenoid
Note: The wires may go on either small post, but
should not share a post.
3. Mount the pump solenoid inside the engine
compartment of the vehicle, ensuring that it stays in an
upright position and does not contact the body, hood,
or other conductive material on the vehicle.
4. Connect the red power/ground cable to the large post
on the pump solenoid
5. Connect the long battery extension cable to the other
large post on the pump solenoid
Original Instructions (EN) All Rights Reserved *MSC12976* A
Printed in the USA
Form No. MSC12976 Rev A
Installation Instructions
Figure 1
4. Pump solenoid
5. Brown wire
6. White/black wire
(Figure
(Figure 1).
(Figure 1).
1).