Table of Contents
Advertisement
Available languages
Available languages
1. Put the power plug to the power socket and make sure power voltage should be 220V/50Hz
2. Put on the power switch,the power lamp will shine.
3. Pull out antenna A and B,adjust them to be 90 angle with the receiver.
4. Link of audio output
5. Turn on the microphone, the"signal lamp"shines. Volume can be controlled with the volume knob.
Do not connect with the power if don't use the system permanently
Handheld microphone operation
1.
Unscrew the cover of battery case in counter-clock wise direction. Install the 9 V battery as below.
2. Put the switch to ON position, the signal lamp will shine at that time,if it dose not shine,please
check with the polarity of battery or test the power of battery.
Note: standby function is between ON and OFF of the power switch, standby status, the mic is still with
power, but it don`t pick up while can resist the noise.
3. Please take away the battery if you do not use the system permanently.
s
c s r c
e r
e n e
n e
e h
e h d a
d a
Microphone Operation
O O
N N
o o P P
w w
r er e
a l
a l p
m
m
p
t s
t s
n a
n a
O
O F F
F F
d
- d
b -
y y b
m
m c i
c i
h
h
o
o
u
u
e s
e s
a ba b
t tt t
er e
y y r
c c
v v o o
r er e
15
Advertisement
Table of Contents
