Quick-Start Guide
POWERLINC
TM
MODEM - INSTEON SERIAL
INTERFACE (DUAL BAND)
Serial RS-232 and TTL Interface (#2413S)
INSTEON
TM
PowerLinc interface with RS-232 serial and electronic TTL
communications for full-time software and hardware host applications.
N N e e e e d d H H e e l l p p ? ? F F o o r r a a s s s s i i s s t t a a n n c c e e c c a a l l l l y y o o u u r r f f r r i i e e n n d d l l y y
s s u u p p p p o o r r t t p p e e r r s s o o n n @ @ 8 8 0 0 0 0 - - 7 7 6 6 2 2 - - 7 7 8 8 4 4 6 6
Key Features
• No background software needed with computer programs
• Straightforward and simplified command set
• Simple to use RS-232 communications
• Direct TTL connection for hardware devices
• Stores over 2,016 INSTEON Links in 128Kb of non-volatile memory
• Uncontrolled feed-through AC outlet other electrical devices
• Communicates via powerline and RF INSTEON for maximum reliability
Connector Specifications
Pin 1: RS232 to PC pin 2 (Rx)
Pin 2: Not Conected
Pin 3: TTL Output (from PLM)
Pin 6: TTL Input (from PLM)
Pin 7: Common ground
Pin 8: RS232 from PC pin 3 (Tx)
Pins 4&5: Not connected
Power-up Behavior
LED On Steady PLM detected an external EEPROM for storage of database links.
LED blinks six
PLM has not detected an external EEPROM and will use the internal EEPROM of the processor chip.
times
While being plugged in, the user pressed and held the SET button for 3 seconds causing the PLM to perform
LED is Off
a factory reset. At the conclusion of the reset, the PLM's LED will operate like one of the two modes above.
Communications
The RS-232 Serial communications to the PowerLinc Modem (PLM) are:
19,200 baud
Note: each byte sent to the PowerLinc Modem will be echoed back to the host.
For developers and programmers interested in learning more about the PowerLinc, information on the PowerLinc Modem Developer
Kit can be found at: http://www.smarthome.com/insteon/sdk2600s.html
8 data bits
2413S Modem
plug-in Jack
No parity
Interface
Port
1 stop bit
Need help?
Do you have a question about the POWERLINC 2413S and is the answer not in the manual?
Questions and answers