Summary of Contents for PARS EcoTech S.L. WM 6.0
- Page 1 PARS EcoTech WM 6.0 Evaporative Cooler Owner’s manual Save Energy, Save our Planet PARS EcoTech S.L. Malaga, Spain info@pars-ecotech.com www.pars-ecotech.com...
-
Page 2: Table Of Contents
Specifications: Table of Contents: General information……............2 Airflow 6000 m3/h Introduction................3 Unit operation.................3 Please note................3 Window section 550*550*260 mm Before starting................4 Installation requirements............6 External cabinet 1180*860*250 mm External fixing of the unit............7 Internal fixing of the unit............8 Net weight 35 kg Problem solving..............10 Water connection..............12 Commissioning..............12... -
Page 3: General Information
Maintenance planner: GENERAL INFORMATION Thank you for purchasing a quality Evaporative Cooler, We care about your safety ALL MAINTENANCE CAN ONLY BE PERFORMED BY A QUALIFIED SERVICE PERSON. and would ask you to spend a few minutes reading these simple instructions before installing or operating this product. -
Page 4: Introduction
GENERAL Water Level / Float Valve The float valve is a mechanical type and is factory set. If the valve is leaking, it may Introduction: require replacement. Your evaporative cooler engineered meet rigors harsh Note: Water connection line to float valve must be flushed before connecting. environments .Used and maintained in accordance with this manual, it will provide you with years of quiet, cool and environmentally friendly operation. -
Page 5: Before Starting
STEP 4: (Optional) Before Starting Always ensure that there is another open window or door through which the The pump hose will be attached to rear filter panel. Should the hose come off air can exhaust to other parts of the house. Refer page 5 correct operation during removal of rear filter panel or be removed for servicing the filters, care and ventilation. - Page 6 1. Turn On/Off: Press the button “ ” in the standby, the Unit starts, the factory default settings: Fan works at minimum speed, cooling mode, Auto Swing works. The unit‘s memory system keeps the fan speed, mode for previous running STEP 1: Remove Rear filter panel fixing screws (4 off).
-
Page 7: Installation Requirements
5. Drain: Press button “drain”, the unit aromatically turn off the motor, water pump, • Press the button “COOL ” in the remote control and operate the three speed fan swing and the drain valve is turned on. The water flushes into the water tank within and pump. -
Page 8: External Fixing Of The Unit
External Fixing Of the Unit Water Connection Ensure that the location chosen to mount the cooler is strong enough to Fit mains water supply line to the float valve installed. The float valve connection is support the operating weight of the unit. The unit is nominal operating weight ½”... -
Page 9: Internal Fixing Of The Unit
Problem Solving PROBLEM PROBABLE CAUSE REMEDY Unit fails to start A-Power Failure A-Wait for power to be turned on. B-Tripped Circuit B-Reset circuit breaker Breaker C-Replace D-Dealer Service C-Blown Fuse D-Electrical Fault Filter Pads not A-Pump Seized A-Refer to Maintenance page. wetting B-Electrical fault with See Pump section. -
Page 10: Maintenance
Drill 2x1/8¡± (3.2mm) holes and insert screws into unit as per diagram and repeat for window frame with appropriate screws. Problem Solving Ensure that the cooler is now fixed rigidly to the house structure. PROBLEM PROBABLE CAUSE REMEDY Excessive humidity A-Not enough air flow A-Increase fan speed B-Inadequate Exhaust...