Advertisement
Troll'n Tab & Lenco Drive 1 Motor Maneuvering
Speed
The speed of the motor can be adjusted to the
desired speed by rolling the speed control knob on
the left side of the foot control. This is a variable
speed system so it offers a full range of thrust
levels. This range is marked 1 through 10. position
1 is marked on the knob by a turtle for the lowest
thrust level. A rabbit for the highest thrust marks
position 10. Use your foot to roll the speed control
knob to the desired setting.
Momentary Mode
When the main control box is turned on, the foot
control begins in the momentary mode. Each time
one of the gray momentary buttons is pressed,
the motors activate; when released the motors
stop. When activated, the motors run at the speed
controlled by the setting of the speed control knob.
Constant Mode
To set the foot control to the constant mode, press
the small gray button on the left at the base of the
foot control one time. This mode allows the motors
to run constantly at the speed selected on the
speed control knob.
Constant
Mode Steering
Adjustments
When the foot control is
set in the constant mode,
it is possible to make small
directional adjustments.
To make each adjustment,
press the right or left gray
momentary buttons one
time. This allows, the boat
to track 5 percent in the
desired direction. If one of
the two momentary buttons
is pressed and held down, the
boat continues to go in that
direction until the button is
released or the opposite button
is pressed.
0
Press
one time
to track
left
5%
Set in Constant Mode
to use Momentary Buttons
for small adjustments
Speed Control
Knob
1
2
3
4
5
6
7
8
9
10
Momentary
Buttons
Press
one time
to track
right
5%
Lenco Marine
Advertisement
