Advertisement
warning! Ensure any object is at least 200cm from the heater front face.
‰
DO nOt leave unattended. When not in use, store the heater carefully in a safe, dry, childproof location.
8
nOte: this appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities
or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a
person responsible for their safety. children should be supervised to ensure that they do not play with the appliance.
2. intrODuctiOn
Stylish modern design heater with 2 heat settings of 700/1400W. Features PTC heat conducting ceramic elements to achieve an instant, odour-free
heat. Includes overheating protection and safety tilt switch, protecting the user, product and environment. Supplied with 13Amp plug.
3. specificatiOn
model no. ................................................................. ch2013
min. Power ....................................................................700W
max. Power .................................................................1400W
input supply .................................................. 230V-13A-50Hz
size (WxHxD).................................................... 210x115x250
feet
tilt safety
switch
4. OperatiOn
warning! ensure you read, understand and apply the safety instructions in section 1 before using the heater.
‰
4.1.
nOte! The ceramic element is fragile and therefore it is important that it is not subjected to any unnecessary shocks or vibration
and is not moved when it is hot.
4.1.1.
unwrap the mains lead, place where required on its six feet and safety tilt switch and plug it into the power supply.
4.1.2.
for fan only select switch position
4.1.3.
choose the required heat output by selecting the appropriate switch.
low setting: select switch with the roman numeral "i".
High setting: select switch with the roman numeral "ii".
4.1.4.
to switch the unit off, turn the heat selecting switch off "o"and unplug from the mains. Allow the unit to cool before handling or storage.
4.1.5.
Safety cut-outs. The heater is fitted with a thermostatic safety cut-out which will automatically turn the heater off should it be
placed in circumstances that cause overheating or malfunction. should this happen, switch the heater off and disconnect it from the
mains.
4.1.6.
Allow the heater to cool before handling. do not use the heater again until the cause has been identified and remedied. if necessary
return he heater to your sealey dealer for servicing. in the event of the heater being knocked over or raised from the ground, a safety
tilt switch, will disable the heater.
4.1.7.
When used for the first time, it is suggested that you set the heater to maximum power for a few minutes in a well ventilated room to
eliminate the newness smell typical of this type of heater.
important: during relocation, the heater should remain switched off and disconnected from the power supply.
9
4.1.8.
In the event the heater has been accidentally knocked over, follow these steps to re-start the heater.
a) Switch 'off' the heater at the "O" position (Fig.1).
b) disconnect the power cord from the power supply.
c) return the heater to a standing position on its four feet.
d) If no damage has occurred to elements, re-connect power cord to the power supply and switch the heater back on. Should the
power cord require replacement, a complete wiring loom should be purchased and fitted by a suitably qualified person.
© Jack sealey limited
illuminates
when heater
is operating
fan only
off
fig.2
Original Language Version
700W-Fan
1400W-Fan
fig.1
cH2013.V2 | Issue 3 31/10/16
Advertisement
