Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for DNF Controls GTP-32
- Page 1 19770 Bahama St. Northridge, CA. 91324 V: 818.898.3380 F: 818.898.3360 sales@dnfcontrols.com www.dnfcontrols.com GTP-32 BREAKOUT PANEL INSTALLATION INSTRUCTIONS Revision 022318 Page 1 of 5...
- Page 2 A. CONNECTING THE GTP-32 UNIT TO THE BREAKOUT PANEL. Look at the back of the GTP-32 unit and note the legend under the 37 pin I/O connectors. The breakout panel has two sets of 37 pin connectors, one set is labeled GPI & GPO and the other set is labeled GPIO. Connect the furnished 37 pin interconnect cable to the matching connector on the breakout panel and the GTP-32 unit.
- Page 3 Pin #2: Ground D. CONNECTING TO A USP3-8/AIB-2 USING ADAPTOR BOARDS When connecting a USP3-8 or AIB-2 to a GTP-32 breakout panel the use of a adaptor board is required. The adaptor board connectors are as follow: J1 Connector DB25 GPIO 1-8...
- Page 4 E. CONNECTING TO A USP3-16/AIB-3/AIB-4 USING ADAPTOR BOARDS When connecting a USP3-16, AIB-3 or AIB-4 to a GTP-32 breakout panel the use of a adaptor board is required. The adaptor board connectors are as follow: J1 Connector DB25 GPIO 1-8...
- Page 5 4) Connect the other side of the DB25 cable into the J1 connector of the adaptor board. 5) Connect the adaptor board into the DB37 GPO 1-16 connector on the GTP-32 breakout panel. USP/AIB PANEL 1) Using a DB25 cable, connect one end of the cable into the GPI 1-8 port of the second USP/AIB panel.
Need help?
Do you have a question about the GTP-32 and is the answer not in the manual?
Questions and answers