Wired GO KART Assembly Instructions

MV RECOMMENDS THE USE OF PROTECTIVE PADS AND
HELMET WHEN USING THIS PRODUCT.
FOR AGE 3+ YEARS
RECOMMENDED TYRE PRESSURE: 30 PSI. CHECK TYRE
PRESSURE EVERY TIME BEFORE USE.
Austin Tower • Room 1001 - 03 1005 - 1007•
10th Floor • 152 Austin Road • T.S.T. Kowloon•
Hong Kong
ASSEMBLY INSTRUCTIONS
1. Attach the steering support to
the frame of the go-kart, using 4
x M5 45mm bolts, dia5 12mm
washers and M5 nuts.
2. Fix the front plate on the
front of the go-kart with 2 x
M5 50mm bolts, dia5 12mm
washers and M5 nuts.
BODY
Screwdriver &
Spanner required.
4PCS X M5 40MM BOLTS
4PCS X M5 45MM BOLTS
2PCS X M5 50MM BOLTS
4PC X DIA5 14MM WASHERS
6PCS X DIA5 12MM WASHERS
10PCS X M5 NUTS
3. Assemble the steering shaft and front panel: Remove
the nut and washers from the Steering shaft (see picture).
Slide the plastic J hook of the front panel into the metal
clip on the frame (see picture). Insert a metal washer and
then a plastic washer to the steering shaft. Insert the
steering shaft with the plastic and metal washer from the
bottom to the car body. The J hook of the steering shaft
should go into the triangle area of the steering linkage.
The steering shaft pass through the car body then
through the steering support tube.
PRODUCT No. M14459
STEERING WHEEL
SEAT
FRONT PANEL
STEERING SHAFT
FRONT PLATE
STEERING SUPPORT
4. Assemble the steering wheel: On the steering shaft,
insert 2 plastic washers (one below the top of the front
panel, the other above the top of the front panel, then a
square metal washer then steering wheel, then a square
metal washer then a metal spring washer an then fix with
a nut.
5. Place the steering wheel
cover in the centre of the
steering wheel.
6. Fix the seat to the frame
of the go-kart using 4 x M5
40mm bolts, dia5 14mm
washers and M5 nuts.
ISSUE 1 - 07/2017