HUFCOR SUMMIT 645V Series Owner's Manual

Electric vertical lift partition

OWNERS MANUAL

SUMMIT SERIES 645V ELECTRIC

VERTICAL LIFT PARTITION

WARRANTY

Hufcor Partitions are guaranteed against defects in material and workmanship for

a period of two years, excluding abuse.

Refer to your Hufcor Limited Warranty Certificate for additional details.

The Hufcor Partitions for this installation have been custom made to the architect's and owner's

specifications. Each partition has been carefully fabricated and installed to provide many years of

trouble-free service.

The key to the life of the product is proper operation and care. The correct operation and

recommended care are outlined in this Owners Manual for your guidance.

If any malfunction of these partitions occurs, please phone your local Hufcor Distributor for service.

This must be done immediately since Hufcor cannot be responsible for damages which result from

delays or failure to advise Hufcor or Hufcor's local Distributor.

This partition was sold and installed by:

When calling either your Hufcor Distributor or Hufcor, please have the following information:

Job Name:

Hufcor Order #:

Installation Date:

Description of the Problem:

Person to Contact:

Table of Contents

Do you have a question about the SUMMIT 645V Series and is the answer not in the manual?

Page 1 Refer to your Hufcor Limited Warranty Certificate for additional details. The Hufcor Partitions for this installation have been custom made to the architect's and owner's specifications. Each partition has been carefully fabricated and installed to provide many years of trouble-free service.
Page 2 Make certain everyone who moves the panels has been trained in their proper operation. Your Hufcor Representative will be happy to provide training assistance if needed. A Summit vertical lift partition consists of a series of individual panels with guide rollers at each end that ride in guide rails located at both ends of the opening.
Page 3 6. Option: Your system may have optional non-contact optical beams that detect objects that may inadvertently move under the partition during operation. IF YOUR PARTITION DOES NOT OPERATE, CONTACT YOUR HUFCOR DISTRIBUTOR IMMEDIATELY. ONE OF THESE SAFETY SYSTEMS MAY HAVE DETECTED A FAILURE. DO NOT ATTEMPT TO MOVE THE PARTITION OR OVERRIDE ONE OF THESE SAFETY SYSTEMS.
Page 4 VINYL FABRIC SURFACE, EXPOSED METAL, AND SEALS The vinyl surface of your Hufcor partition may be cleaned with warm water and mild soap. Sponge the surface clean and wipe dry with a soft cloth. A soft brush may be used if dirt is difficult to remove. Carbon tetrachloride may be used for removal of grease and oil.