Advertisement
. When connecting the external unit, refer to the owner's manual of the external
unit, as well as this manual.
. When connecting the external unit, make sure the power is OFF and both units
are unplugged before making any connections.
. Connect a CD+G player to utilize the VOCAL Button, see later in this guide.
USING A MEDIA PLAYER
1. Insert your multimedia player into the Multimedia Player Holder.
2. Connect the Line In cable from the Line Out of your multimedia player to the
MEDIA In Jack on the top of the Amp. Connecting the multimedia player will
allow you to hear its sound through
this unit's speakers.
3. After connection, press the SOURCE Button repeatedly until the red indicator
flashing to switch to MEDIA-IN mode.
NOTES: If using a tablet, make sure to strap the tablet in using the supplied strap.
The MEDIA In Jack should be used if multiple source inputs are used.
STAND ADJUSTMENT
To lower or raise the Top Stand bar, simple rotate the Height Adjustment Collar
counter-clockwise to loosen and then raise or lower the Top Stand Bar. Rotate
the Height Adjustment Collar clockwise to tighten.
GENERAL OPERATION
1. Make any desired connections as shown previously. Rotate the master volume
knob clockwise until a click sound heard to turn the unit on.
2. Turn microphone's ON/OFF Switch to the ON position. Repeat for microphone
2, if desired.
3. Adjust MIC-1 Volume Control as desired.
4. If using a second microphone, adjust MIC-2 Volume Control as desired.
5. Rotate the ECHO Control clockwise to increase the echo or counterclockwise
to decrease the echo.
6. Press the VOCAL Button to the "in" position to activate this feature. When the
Vocal Auto Feature is activated, the vocals on a multiplex recording are muted.
7. Turn on the external unit or multimedia player and sing or talk into the
microphone(s) and you will hear both the external unit/multimedia player and
the microphone.
8. If a Guitar is connected, set the desired volume using the GUITAR Volume
Control.
5
Advertisement
