Venture Lighting AV0004-A User Manual

V L
E N T U R E I G H T I N G ' S
STOP

Before You Begin

Read These Instructions Completely and Carefully
Upgrade Instructions: Slipfitter Mount
STEP 1: Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or
maintenance.
STEP 2: Remove the existing luminaire. Dispose of the lamp(s) and ballast(s) per local requirements.
STEP 3: Slipfitter mount fits a 2 3/8" OD tenon (A).
STEP 4: Place slipfitter over the tenon and secure the fixture using the set
screws (B) on the side of the slipfitter.
NOTE: Take note NOT to pinch any wires when closing the wiring enclosure.
STEP 5: To adjust the aim of the fixture, remove the round cover plate. (C)
STEP 6: Loosen the locking bolt, aim the fixture as desired and then tighten the
locking bolt. Secure the round cover plate. (C)
STEP 7: Connect the fixture input leads (D) to the supply wire leads.
(D)
Wiring Diagram
(+) LINE
(-) COMMON
GROUND
STEP 8: Each fixture is supplied with a twist lock shorting cap. For the fixture to function, the shorting cap MUST be installed.
Note: An accessory twist lock photocell may also be installed in place of the shorting cap.
STEP 9: Power can now be restored to the fixture.
(877) 281-1233
Fax: (877) 294-2829
2451 Enterprise Parkway East
Twinsburg, Ohio 44087 USA
E-mail: venture@adlt.com
VentureLighting.com
© 2016 Venture Lighting International • Venture Lighting is a registered trademarks of Venture Lighting International.
L E D R
O U N D B A C K
BLACK
WHITE
LIGHT
FIXTURE
GREEN
U
F
SER
L O O D
Set Screws
B
Tenon
M
ANUAL
A
C
Round
Cover Locking
Plate Bolt
AV0004-A