Orbyx Electronics Nexxtech Series User Instructions

CMOS: GPL081A3-487A
Suitable Model: C8236
6302000
User's Instructions
RC WALL CLOCK
WITH INDOOR THERMOMETER
GETTING STARTED
1. Remove the battery door by slightly pressing the
knob downwards.
2. Insert one new AA size battery according to the
polarity information marked on the battery
compartment.
3. Close the battery door.
4. When the battery is inserted, the normal LCD display
will be shown before entering the radio controlled
time reception mode.
5. The RC clock will automatically start scanning for
the radio controlled time signal in 8 seconds.
Note:
If there is no display on the LCD after inserting the battery,
try to replace with one new AA size battery or press the
"RESET" key. In some cases, you may not receive the RC
signal immediately. Due to the atmospheric disturbance,
the best reception often occurs during nighttime.
FUNCTION KEYS
RESET key: Press to return all values to default values.
In case of mal-function, the unit may
be required to reset.
MODE key: Press to toggle between normal time mode
and alarm time mode.
SET key: Press to turn the alarm and snooze on/off.
Press to stop the current alarm when
the bell is ringing, and to turn off the alarm
and snooze function.
ADJUST key: In normal time mode, press to switch
between Month/Date and Year display.
In alarm time mode, press to select
the proper time zone.
In setting mode, press to change the
setting values.
˚C/˚F key: Press to switch between Celsius and
Fahrenheit.
Press and hold for 3 seconds to
receive the RC signal for reception
testing.
SNOOZE key: Press to stop the current alarm when
the bell is ringing.
PRODUCT SETTINGS/DISPLAY
1. LCD display
2. RESET
3. MODE key
1
4. SET key
5. ADJUST key
6. ˚C/˚F key
7. SNOOZE key
8. Wall-mounting holder
9. Table stand
10. Battery door
PANTONE: 445C
2
3
4
5
6
7
Normal Time Mode
1. Time 5. Daylight savings time (DST)
2. Date 6. Signal strength indicator
7. Day of the week
3. Month
4. Time zone map 8. Temperature
1
2
3
Alarm Time Mode
1. Alarm time
1
2. Alarm icon
3. Snooze icon
4. Alarm mode
DAYLIGHT SAVINGS TIME (DST)
The clock has been programmed to automatically switch
when the daylight savings time is in effect. If you live in an
area where DST is not observed, the time display on your
clock will read +/- for one hour during the DST period.
WWVB COVERAGE MAP
Note: Radio Controlled Clock may not work in some
locations or areas.
SIGNAL STRENGTH INDICATOR
The signal indicator displays signal strength in 4 levels.
Wave segment flashing means time signals are being
received. The signal quality is classified into four types:
If the RC clock receives the signal successfully, a sync-time
symbol " " will appear on the LCD.
SIZE: A5
8
9
10
4
5
6
7
8
2
3
4