Summary of Contents for Cell2 SAF101H
- Page 1 12/24VDC Model SAF101H Electronic Handheld Siren Installation And Operation Manual NOTICE TO INSTALLER Before installation and use -- read all instructions and warnings. Deliver this manual to the end user of this equipment. Doc. No.: SAF101H Siren_v.1.0...
- Page 2 5. Once every switch is set, press and hold SIREN and RADIO for 3 second to exit PROGRAMMING MODE. VOL- and VOL+ will stop blinking to indicate that you have exited from PROGRAMMING MODE. SAF101H Siren_v.1.0 - 9 - SAF101H Siren_v.1.0...
-
Page 3: Table Of Contents
3. Once set, press MAN button again to save the setting; press and hold SIREN and RADIO for 3 second to exit PROGRAMMING MODE. VOL- and VOL+ will stop blinking to indicate that you have exited from PROGRAMMING MODE. SAF101H Siren_v.1.0 - 8 - - 1 -... -
Page 4: Specifications
SW1, SW2, SW3, SW4 (Light), +VDC, -GND, IGN(Ignition), RAD(Radio) x2, Connections HORN(Horn Ring Transfer), SPK x2 . (Removable12-P Terminal Block) VOL- VOL+ Dimension Siren Amplifier : 161mm x 178mm x 69mm Controller : 56mm x 140mm x 33mm SAF101H Siren_v.1.0 - 2 - - 7 - SAF101H Siren_v.1.0... -
Page 5: Installation
The correct mounting and wiring is the key to the effectiveness of overrides all other acoustic function (i.e. Air Horn, Siren Tone and Radio Rebroadcast) SAF101H siren. Installers must read and follow installation instructions and warnings in while it is activated. -
Page 6: Wiring
Speaker Output Connection – Both connections must be used. Two speakers may be connected in parallel. NOTE: The controller is shipped without any button plates or decals installed. Place decal onto button plates, then install plates onto each button. SAF101H Siren_v.1.0 - 4 - - 5 - SAF101H Siren_v.1.0...