Strong SR-CS-RACK-16U Assembly & Instruction Manual

KNOCK-OUTS
To accommodate fans or wire pass through, there are (2) 120mm-diameter
cut hole patterns in both the top and bottom plates of the rack. To remove,
simply use a hammer to knock the plates out and remove. Do not remove
more than one knockout from each plate.
* If running wires through holes is needed when stacking two racks
together, remove the same knockout from both the top and bottom plates.
OPTIONAL FEET (Included with Rack Hardware)
Also included are 4 hard plastic, stationary feet. If casters are not desired,
simply unscrew casters and use stationary feet instead.
CAUTION - feet may damage flooring if rack is moved when loaded
with equipment.
ACCESSORY INSTALLATION
• Determine the layout of your components, their space requirements
and where you will place vents or blanks.
• Unbox your first shelf, starting with the one you will place at the bottom
of the rack. The heaviest components should be placed as low as possible.
• Unfold shelf side panels and mount in desired rack location using four
Strong™ rack screws. Accessory mounting screws are not included with
shelves, vents or blanks (only with racks).
• Install component onto shelf.
• Unbox and install the next shelf, vent or blank following the above steps.
A vent should be placed above components that generate excessive heat,
such as surround receivers, amplifiers, satellite receivers, DVR's, cable boxes
and media servers.
NEED RACK SCREWS?
Screws are not included with our rack accessories, but extra screws are
available (SR-SCREWS-200JAR). One no-roll jar includes 200 black 10/32
screws featuring #2 Phillips heads and captive nylon washers.
Lifetime Limited Warranty
All Strong™ products have a Lifetime Limited Warranty. This warranty includes
Lifetime parts and labor repairs on all components found to be defective in material or
workmanship under normal conditions of use. This warranty shall not apply
to products which have been abused, modified or disassembled. Products to
be repaired under this warranty must be returned to SnapAV or a designated service
center with prior notification and an assigned return authorization number (RA).
For Techincal Support : 1.866.838.5052
ASSEMBLY MANUAL
SR-CS-RACK-12U
120309-1419
CONTRACTOR SERIES RACKS
SR-CS-RACK-16U SR-CS-RACK-21U