Bircher ArtMotion 2 Original Instructions

ArtMotion 2
Original instructions
General
b a
ArtMotion 2
1

Safety instructions

Observe the national and international regulations on door safety.
Only trained, qualified personnel may mount and start up the detector.
The unit may only be opened and repaired by Bircher Reglomat.
The unit may only be operated from a safety extra-low voltage (SELV) system with safe electrical separation.
Always consider the safety functions of your application as a whole, never just in relation to one individual section of the system.
The installer is responsible for carrying out a risk assessment and installing the detector and the door system correctly.
Avoid touching any electronic components.
The door drive and transom profile must be earthed correctly.

Start-up

Recommended start-up sequence:
2

Montage

I
1. Remove cover hood

Mounting of the detector

1. Position drill template
2. Drill the holes, remove drill template
3. Lay cable and mount detector
3

Electrical connections

II
ArtMotion 2
white
Power
brown
Supply
green
Radar
yellow
output
4

Mechanical fine tuning

Manual settings of the
inclination
0° ... +45° in 5° steps
–
+
+
–
Radar field
Radarfield
I. Mounting II. Connection
2. Lay and connect cable
Controller
white
12–36 VDC
3 m
brown
12–28 VAC
green
Cable
yellow
Radar
Wide radar field
1m
2m
3m
Inclination angle: 35°
0m
1m
2m
3m
2m
4m
min. = 1.6 x 0.8 m
max. = 4.8 x 2.3 m (WxD)
Microwave motion detector for opening



3. Mount detector
turn 90°
a
b
90°
0m
1m
automatically controlled doors
a Hood
b Light window detector indication
 Cable bushing
 Mounting
 Microwave module
 LED microwave: green
 Potentiometer
  
Narrow radar field
1m
2m
3m
Inclination angle: 35°
0m
1m
2m
3m
4m
min. = 0.8 x 1.6 m
max. = 2.3 x 4.8 m (WxD)
351084A
12/15
0m
1m
2m
1