Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for SadoTech StarPoint LD
Summary of Contents for SadoTech StarPoint LD
- Page 1 User Manual for Door-Open Chime North America Office: European Office:...
- Page 2 Features Introduction a. Receivers: Plug-in/ Battery-operated types; With LED indicator, music control and volume control button. Plug-in type requires no battery; Battery type needs 3 AAA batteries, with wall-Mounted design. b. Transmitter (door sensor): One 1.5 V AA battery is required; With LED indicator;...
- Page 3 Product Diagram (Receiver) ___________________________________ 2 ___________________________...
- Page 4 Product Diagram (Door Sensor) 1. Remove insulating strips in receiver or door sensor and pair sensor to receiver (see setup instruction) 2. Test and find the right place and distance to install receiver 3.Notes about battery: low power in receiver or transmitter will shorten the transmitting range.
- Page 5 Setup Instructions 1.Pair door sensor(s) with receiver: Please do the following steps as soon as possible since receiver will exit learning mode automatically if it doesn't get signal from transmitter in 5 seconds. In order to avoid interference, pair 1 transmitter only at any given time. a) Select desired ring tone by pressing music control button b) Set receiver into learning mode (pairing mode) by either method i) or method ii) below.
- Page 6 Installation Methods NOTE: Please first make pairing or reselect melody, then test whether the operation ranges you choose is proper and prepare an electric drill or hammer, cross screwdriver and slotted screwdriver if you prefer to fix transmitters by screws. Installation of Receiver: Plug-in type: Just plug it into any outlet.
Need help?
Do you have a question about the StarPoint LD and is the answer not in the manual?
Questions and answers
how do you change the battery from the doorbell transmitter
The context does not provide specific instructions for changing the battery in the SadoTech StarPoint LD doorbell transmitter. However, it does state that the transmitter requires one 1.5V AA battery. To change the battery, you would typically open the battery compartment on the transmitter, remove the old AA battery, insert a new 1.5V AA battery, and close the compartment securely.
This answer is automatically generated
I have two receivers and two transmitters. Labeled MagicFly but I guess Sadotech bought them out? I want one transmitter to pair with one receiver only and the other receiver to pair with the other receiver only.
To pair one SadoTech StarPoint LD transmitter with one receiver and another transmitter with a second receiver, follow these steps:
1. Pair the first transmitter with the first receiver:
a) Press the Music control button on the first receiver to select the desired ring tone.
b) Put the first receiver into learning mode:
- Either press the Volume and Music control buttons on the receiver simultaneously, or
- Press the Volume control button on the receiver for 5 seconds until you hear a chime and see the LED flash.
c) Trigger the first transmitter by separating its two parts until the indicator lights up and the receiver plays the selected tune. This confirms successful pairing.
2. Pair the second transmitter with the second receiver:
a) Press the Music control button on the second receiver to select a different ring tone if desired.
b) Put the second receiver into learning mode using the same method as in step 1b.
c) Trigger the second transmitter the same way as in step 1c.
Each transmitter is now paired with its corresponding receiver.
This answer is automatically generated
How do you change the battery on the doorbell component? I don't want to break the outer case