Quarq Qollector Qollector

Qollec tor
Charging Port
Power Meter
Indicator
Heart Rate
Indicator
Other Ant+
Indicator
Commands
Press and hold the
the Qollector on or off. When powering on, the status
Q Button
icons will light up green and the Qollector will beep
and vibrate. When powering off, the icons will flash
Cellular Status
red and the Qollector will beep and vibrate.
To pair the Qollector with a sensor, press and release
GPS Status
the
corresponding white icon will light up when the
sensor is paired. Up to 7 sensors can be paired with
Battery Status s
the Qollector.
Press the
Status, and GPS Status. The
on and connected.
Press - 3 Sec
Press
for three seconds to power
and hold the Qollector near the sensor. The
to check the Cellular Status, Battery
will blink often when
Using the Qollector
Create an account on QuarqNet.com to view, upload, and sync
your data.
To start an activity, power ON the Qollector.
Wait until the GPS light is green (GPS locked) before moving.
A green Cellular Status light indicates both a cellular connection, and
that all pending data is uploaded. Data is uploaded every minute and
can be viewed live on QuarqNet.com.
An orange or red Cellular Status light indicates that all pending data
is saved, but not uploaded. Data will automatically upload and be
sent to your autosync destinations when cellular service returns.
To finish an activity, power OFF the Qollector.
Your activity will be uploaded, created, and named in QuarqNet.com,
and sent to your autosync destinations. If you do not have a cellular
connection, Qollector will automatically send your data when cellular
service returns.
For complete instructions, visit our website at QuarqNet.com.