CONTENT INTRODUCTION • Package Contents SAFETY INFORMATION • Warning • Responsibilities BT LINK CONTROLS GETTING STARTED • Charging • Pairing • Attaching to Helmet • Connecting to Music USING THE BT LINK • Turning on and off • Making Calls •...
TuneUps with Bluetooth LINK TuneUps™ offers incredible in-helmet stereo sound plus Bluetooth LINK™ technology from Skullcandy™ that allows you to hard-line to your music player while connecting to any Bluetooth enabled phone wirelessly. A simple touch answers incoming calls while one more disconnects you and gets your music back online.
SAFETY INFORMATION WARNING For use with Giro snowsports helmets only. Use of these or other headphones in snowsports may cause the rider/skier to not hear approaching riders/skiers. This can lead to an accident and possible injury or death. Headphones will also restrict your ability to hear what your edge/edges are doing on the snow, which may lead to less control.
BT LINK CONTROLS << ILLUSTRATION >> 1 – Multi-function Logo Button Used to answer and end calls. Also used to turn the BT LINK on and off. 2 – Microphone Used when placing and receiving calls 3 – Volume Control Dial Allows you to increase or decrease volume for music or calls. 4 –...
Page 5
Put your BT LINK into pairing mode With your BT LINK off, press and hold the Logo Button until the LED alternately flashes blue and red (about 5 seconds). BTLink-SK/Giro Set your phone to look for your BT LINK, and select “ ” from the device list.
Page 6
Connecting the BT LINK to Your Helmet or Headphones Connecting the BT LINK to your helmet Perform these steps to connect your BT LINK to your helmet. Remove the standard earpads already installed on you helmet, and attach the included TuneUps Audio Earpads. Refer to your Helmet User Guide. Connect your BT LINK to the Audio Earpads using the included 3.5mm-to-3.5mm stereo audio cable.
USING YOUR BT LINK Turning Your BT LINK On and Off To turn you BT LINK on, press and hold the Logo button for approximately 3 seconds until the LED flashes on for one second and you hear a short tone. To turn you BT LINK off, press and hold the Logo button for approximately 5 seconds until the LED flashes on for one second and you hear a long tone.
• • • Blue flash twice per 2.5 No audio Standby mode un- seconds indications paired • • • Blue flash once per 2.5 No audio Standby mode seconds indications paired • • • Blue flash thrice per 2.5 No audio Conversation in seconds indications...
Giro, the Giro logo, TuneUps™, and other Giro marks are owned by Giro and may be registered. The Bluetooth wordmark and logos are owned by the Bluetooth® SIG, Inc. and any use of such marks by Giro is under license LINK™ is a registered trademark of SkullCandy ® .
Need help?
Do you have a question about the BTLINK and is the answer not in the manual?
Questions and answers