Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS RANGE ELECTRIC
Fitting the plinth (if applicable)
•
Ensure the appliance is raised to a
height of 915mm or above using
adjusting feet (A) before beginning.
•
Open the appliance doors and loosen
screw (C), do not remove the screw
entirely. If your appliance has a stor-
age drawer at the bottom, you access
the screws through holes located at the
base of the drawer after lifting the mat.
•
Fit plinth (B) and secure using screw
(C).
CONNECTING THE ELECTRICITY SUPPLY - TERMINAL BLOCK
•
The appliance must be fitted to a switch providing all pole disconnection with a
minimum contact separation of 3mm.
•
Access to the mains terminal is gained by removing the terminal block cover at the
rear of the appliance.
•
Connection should be made with a suitable flexible cable.
•
First strip the wires then push the cable through the cable clamp.
•
Connect the cable to the terminal block and tighten the cable clamp screws - see
diagram.
•
Refit the terminal box cover.
•
Sufficient cable should be used to allow the cooker to be pulled out, but must hang
clear of the floor so it does not become twisted or trapped when the cooker is
pushed back.
Please ensure that the user has this copy of the handbook, and the appliance is in
place.
DOOR
A
B
PLINTH
OVEN CAVITY
C
Advertisement
Table of Contents
