Page 4
Assembly 1.1 Insert the connector housing 16x into the round holes on top of the bedsides - make sure the arrow is pointing to the hole. 1.2 Attach the support plate 8x to the frame with the Euro-screw 32x. 1.3 Insert the joint connector 8x into the holes at the ends of the bedsides.
Page 5
2.1 Connect the four bedsides. 2.2 Tighten by turning the connector housing 8x to the right with the allen key - only 3/4 turn needed. To avoid the bed base from sliding, stick the rubber pad 6x to the bed hook 6x.
Page 6
4.1 Insert the plastic leg 1x into the middle beam. 4.2 Attach the bed hook 2x to the middle beam with the 20mm screw 4x. To achieve the desired height of your mattress, hook the bed hook 6x into the support plate 6x on the level of your choice.
Page 7
Turn the plastic leg 1x to the left to extend it and give it the desired length. Please note: when there’s too much empty space between the bed bases and the bed- frame you can put the dowel 60 mm 2x into the holes in the middle beam. To enable a fixed position for the bed bases.
Page 8
Assembly headboard Mount the metal bracket 2x on the bed head end using the screw 16mm. Mount the headboard on the metal brackets of the bed using the screw 16mm.