Abitana ABI-ET2001 Quick Start Manual

ABI-ET2001
Telephone Connection Module
4 lines
Quick Start Guide
1 Package Contents
•
Telephone Connection Module 4 lines
•
Quick Start Guide
2 Introduction
The ABI-ET2001 is a passive telephone distribution module suitable for
standard (PSTN) and digital (ISDN) phone lines.
This unit provides easy connection of Telephone, FAX and/or ISDN
equipment like Telephones, modems or bank terminals
The ABI-ET2001 does not have a privacy protection device
incorporated.
3 Hardware Introduction
Positie
A <-> B
ISDN
P1
The DIN-Rail mountable ABI-ET2001 is equipped with 4 RJ45 jacks on
the front of the unit. (P1 ~ P4)
Three switches on the front of the unit are used to configure the unit
according to the needs of your installation. Different configuration
scenarios are explained later in this manual.
On the top of the unit you'll find the connections for the 'incoming'
phone lines
The switches and the incoming phone line connections are only
accessible when the front of the 'Comm Center Cabinet' is removed.
English
090810_ABI-ET2001_QSG_ML
L2 L1
P2 P3 P4
Figure 1
The unit will probably be configured during installation. Make sure to
take note of the configuration (Connections to the rear ports and switch
settings). At the end of this manual, you will find a table where you can
write down the configuration.
4 Installation and power
No power needed.
Load ratio for this module = 0.
Maximum allowed load ratio (sum of the load ratios for all modules) for
power supply ABI-PS1001S00 = 4.
Click the module on the DIN-Rail as shown in the pictures below:
5 Installation scenarios
The switches on the front of the unit (see Figure 1) )can be placed in
two positions (A and B). A number of combinations is possible, but not
all possible combinations are allowed (depending on the external
connections to ISDN, L1 and L2, and the connected devices to P1 ~
P4)
5.1 One analog (PSTN) phone line
When you have one incoming telephone line (standard PSTN), you
can distribute the signal to 4 locations in parallel.
When a call arrives, all phones will ring at the same time. You can pick-
up any of the four phones to answer the call.
If during a call a second phone is unhooked, this phone will join the
ongoing conversation.
No internal calls between the locations are possible (NO PABX
function).
For this configuration, the switches must be in the positions indicated
in the preceding table.
Page 9
ENGLISH
Switch Nr. Position
S1 A
S2 A
S3 A
abitana
N.V. S.A.