Display Explanation; Safety Precautions - GRAUPNER POLARON Operating Instructions Manual

◎ DISPLAY EXPLANATION

- Load gauge
. 2.5A/ Section
ex)
5 sections means
12.5 ~ 15A
◎ FEATURES
- The stable DC 12V output by switching power supply system
- The rated 25A (Max 30A) is able to cover all of Graupner/SJ charger
- AC100-240V/50~60Hz Input
- 0~40℃ Category temperature range
- Shot circuit / Over voltage / Over current / Over power protection function
- 100% full load burn-in test.
- Built in ON/ OFF switch
- Heat suppression design by built in cooling fan and compact circuit
- Several devices can get the power from muti-output at a time
- 5.0V, 1.0A output throughout USB terminal
- Shot sensing circuit design
- Easy to carry by small size and light weight
- Docking system with POLARON EX/PRO Charger
- Easy to check the actual voltage and current on LCD
- Enable to check the external temperature on LCD
◎ OPERATING INSTRUCTION
1. Read thoroughly the following instruction before using.
2. Disconnect the power supply from AC mains power before connecting the device to the
power supply.
3. Connect the device to the power supply ensuring the correct polarity. Red is positive, Black
is negative
4. Connect to the charger (POLARON EX/PRO) that can be used in Docking system with the
double gold connector
5. Switch " OFF " with the switch on the rear of this unit and connect AC power cable
6. Switch " ON " with the switch on the rear of this unit then this unit initiates to supply the
power
NOTICE: The actual voltage and current should be in the specification of this unit
7

◎ SAFETY PRECAUTIONS

. Never input AC power to DC output terminal
. When POLARON EX/PRO is in Docking with this unit, never input the power to POLARON EX/
The actual output
voltage from SMPS
PRO from the other power supplier. It may cause damage to the charger and power supplier.
. The output terminal on the side of this unit is for Docking terminal with POLARON EX/PRO.
Other charger should use the output terminal on the front
The actual output
. Do not leave this unit unattended while it is working. The initial reaction is very important in
current from SMPS
case of damage or fire.
. Be cautious about the short circuit for output cable
The external
. Do not use the too shot cable or damaged cable.
temperature
. Do not reverse the positive and negative terminals. Wrong connection will damage the battery
and the charger
. Be sure to use this unit within the specification
. Do not allow water, moisture or foreign objects into the charger
. Do not use in humid place and do not operate with wet hands
. Make sure to stop operating this unit when it gets wet, the out of order of by moisture might
not be repaired.
. Make sure to stop operating if there is a smell of burning in this unit or it is too hot.
. Do not attempt to modify or disassemble this unit. In this case, A/S might not be provided.
. The repair will be paid for by the consumer when the damage is due to use in improper ways
or beyond the warranty period.
. Do not use on the fleecy material such as carpet, blanket, bed, cushion and make sure to use
in a hard and flat surface
. Do not use in too hot or cool place and the place exposed to direct sunlight.
. Make sure to use in a well ventilated place and do not block the cooling fan (rear)
. Always disconnect all devices, battery and AC power after charging
. This product is only intended for use with unmanned, hobby-grade remote-controlled vehicles,
aircraft, helicopter and boat. OPENHOBBY disclaims all liability outside of the intended purpose
and will not provide warranty service related thereto.
Age Recommendation: Not for Children under 14 years. This is not a toy.
8