RSI Extreme Stunt Instruction Manual

Operation Direction (Mode 2) Fine-Tuning Operation (Mode 2)
Push the throttle up or down, the helicopter flies upward or While helicopter is descending, push the fine- tuning button
downward. up. While helicopter is ascending, push the fine-tuning
button down.
Push the direction control rod up or down, the helicopter While helicopter moves forward, push the fine-tuning button
flies forward or backward. down. While helicopter moves backward, push the
fine-tuning button up.
SPARE PARTS LIST
Order by item number from Extreme RC by RSI.
Push the direction control rod left or right, the helicopter While helicopter turns left, push the fine-tuning button right.
flies left or right. While helicopter turns right, push the fine-tuning button left.
1 Head cover
#
# 6 Wobbler
Push the throttle left or right, the helicopter flies left or right.
WARNING
• Do not block the transmitter lens on top of the remote control unit.
• Do not place stickers, weight, or anything else on the helicopter. This may cause the helicopter to crash or malfuncrion.
• Avoid flying the unit under low ceilings. Crashing into ceilings may cause damage to the helicopter.
• To avoid injury, do not touch the blades or any other moving parts. 11 Gear #
• When not in use (especially for 30 days or more) remove 'AA" batteries from remote control unit
– batteries may leak and cause damage.

ENVIRONMENT FOR FLIGHT

• Recommended flying area for indoor/outdoor: 20'L x 20'W x 12'H (6.09 meters L x 6.09 meters W x 3.65 meters H)
• Avoid drafts, forced air, water, fans, heat and air conditioning vents.
16 Bearing
#
• Keep flying helicopters away from pets, young children, the elderly and the disabled - use good common sense when flying!
-5-
Distributed and Serviced by: Extreme RC by RSI ... Ferndale, MI
4-CHANNEL GYRO SYSTEM
STUNT
Single Blade ... Remote Control Helicopter
Features Gyroscopic Stabilization Technology
for Smooth, Easy-to-Control Flight!

PACKING LIST

Head cover
2 Main frame 3 Landing gear 2 Landing gear 4 Main blades 5 Tail blades
# # # # # USB charging wire
F3-04
主风叶
Extra blades
# 7 Tail set # 8 Balance bar # 9 Shaft # 10 Steering engine pull rod
Charger
# 12 Main motor # 13 Tail motor # 14 Circuit board # 15 Battery
4
17 Charger base 18 Coinnect buckle 19 USB charge wire 20 Remote control
# # # #
-6-
Tel: 586-757-1336 x 1 ... E-mail: Service@extremercbyrsi.com
Instruction Manual
Li-ion
R Charging Battery
1) Remove batteries from the package
Li-ion
2) Insert them into battery charger base
Charger
3) Insert one end of USB charging cable into
the base, the other into a computer USB port or
Insert USB charging cable into A/C adapter
4) Look for red charging indication light on the
L ED Indicator
charger base, the light turns off when fully charged
Red Light OFF
Charging Completed
USB Charge Wire
Extra A/C Adapter
Assembly of battery to helicopter
Packing list

Battery installation

Charging instructions

Flying instructions

Calibration trim control

Safety instructions

Parts list by number

Insert fully charged battery into
the socket and press tight.
Body frame
Remote control
When the indication light starts flashing, place the helicopter on a horizontal surface, push the
throttle all the way down. Turn the remote control switch on, the remote control indicator will
flash for 5 seconds with alarm sound, then the light stays on. The helicopter is now ready to fly.
Li-ion batteries A/C Adapter
4
-1- -2-
Red Light ON
Charging
0 1 Strife fine-tuning: Power-on start in the 1 0 Turn left : Power-on start in zero.
centering.(Be Turn Left/Right Fine-tuning in 1 1 Turn right: Power-on start in zero.
Mode2) 1 2 High speed mode:Power-on without display "H".
1 3
0 2 Forward/backward fine-tuning: Power-on start Low speed mode: Default mode when power-on
左右微调
in the middle. with "L". (Change to H mode when press button"B".)
1 4
0 3 Turn Left/Right fine-tuning: Power-on start in Power shows: According to the battery's energy
centering. (Be Strife Fine-tuning in Mode2) for the controller.
0 4 1 5 MODE 2 : Push the button "A" to right to change
Throttle lever fine-tuning: Power-on start in
In MODE 2, Strife controlled by left lever, turn
middle.
0 5 left/right controlled by right lever.
Throttle shows: Power-on start in lowest level.
1 6
(Left and right throttle shows at one time) Signal shows: Normally to full frame.
0 6 Forward shows: Power-on start in the lowest 1 7
Mini helicopter shows when power on with on
level.(At the center square)
function now.
0 7
Left Strife shows: Power-on start in the
lowest level.(At the center square)
0 8
Backward shows: Power-on start in the lowest
level.(At the center square)
0 9 Right Strife shows: Power-on start in the
lowest level.(At the center square)
-3-