Advertisement
an LED at the same time. These are referred to as
Sound, Flash, and Sound+ Flash mode.
To select the notification mode, switch the
sound and flash switch to the one of the
following positions:
Sound only mode
Sound +Flash mode
B. Selecting the ringtone:
There are 36 programmable ringtones for
selection.
Press the Ringtone selector button
change the ringtone.
Stop pressing this button when you have
reached the desired ringtone.
C. Adjusting ringtone volume:
Press the Volume button
volume is set. There are 3 volume levels for
selection.
D. Pairing additional push buttons/receivers to the
doorbell system:
- 05 -
Flash only mode
to
VOL
until the desired
1/2/3
Up to 5 push buttons can be paired with one
receiver. You can also extend the wireless
doorbell system with any number of receivers.
This is only possible if the push button and
receiver are working on the same frequency.
Pair additional push buttons/receivers using the
same pairing process as described below:
The following pairing instructions are relevant
to receiver (SKU: O00QH-0504) and push button
(SKU: O00QH-0503).
Press the Pairing button
receiver. Next press the push button. If pairing is
successful, the receiver should ring. It normally
takes about 10 seconds for the push button and
receiver to pair. If there is no pairing within 10
seconds, the receiver will exit the pairing mode.
Please try pairing again.
E. Re-pairing function:
If a receiver starts ringing even when the push
button hasn't been pressed, or a push button
interferes with other receivers, it may be
necessary to wipe the current pairings and pair
again.
- 06 -
on the back of the
Advertisement
