Samsung Scanthru Window - Samsung SF-5100P User Manual

Samsung ScanThru window

The controls of the Samsung ScanThru window are described below.
Image Type: Selects an image type used for
scanning.
Scan To OCR: If this button is checked, the
scanned document will be automatically passed to
OCR programme for text recognition.
Brightness/Contrast: Adjust the brightness to
make the image lighter or darker. Also, adjust the
contrast to sharpen the image definitions.
The dotted rectangle
defines the size and position
of image area where the
scanned picture
should appear.
Resets all the controls to their default values.
Starts scanning. The scanned image will be saved in
Incoming folder of Samsung ImageThru.
Scans an image at 75 dpi resolution. This is useful for
preliminary testing of scanner setup etc.
The scanned image will replace the picture in the
sample picture area.
Exits Samsung ScanThru.
Brings up the help file.
Resolution: Selects a resolution used for scanning.
Save Mode:
Minimize Time mode results in less image storage time, while
increasing the disk space required to store an image.
Minimize Size mode decreases disk space occupied by stored
images , while increasing storage time. Save Mode selection is
available only when you are scanning images that are stored in
Samsung ImageThru. This selection is disabled when scanning
to Fax or to E-mail because images are not stored in Samsung
ImageThru.
Sample picture
Scanning with Samsung ScanThru
Image Area: Allows you to select the size of
image area. You can also change the size by
resizing the image area marquee in the sample
picture area.
Left, Top: These settings define a position of the
top left corner of the image area. Enter the
desired value. (Don't forget to set the
appropriate measurements unit using the Unit
radio buttons.) You can also change the start
position by dragging the image area marquee.
Set the cursor inside the marquee (the cursor
turns into a four-headed arrow) and drag the
marquee to change its position.
3.5