PetMartop PET681V User Manual

PET681V
Vibration
Anti Bark Collar User Manual
Product Manual
Please Read this Manual Carefully before Using
Thank you for purchasing the anti bark collar
Step1 Step2
Screw probes on electrodes
Remove the faceplate
Install the ba ery
Step3
Beep sound
Blow into the small hole
Vibrate
Red LED light remains on
1
Safety warning - please read before using:
Do not leave collar on dog for more than 6-10 hours to
avoid pressure necrosis due to the probes touching the
skin.
Do not put on dog when dog is sleeping, laying or unattended.
Make sure probes are a finger width apart from dog's neck
(stick your finger between dog's neck and the probes to test)
Important Note:
When the collar is fitted correctly, IT DOES NOT MOVE.
You can slide just one finger under the collar.
If it is NOT FITTED CORRECTLY, it will go off randomly
and will not work when your dog barks.
Introduction:
The anti-bark collar stops barking with progressively
increasing sound and vibration which is controlled by a
microprocessor distinguishing your dog's bark from other
environmental noises and automatically delivers sound
and vibration after each bark.
PRINCIPLES OF OPERATION:
Anti bark collar has 7 correction levels, which deliver
different sound and vibration combinations:
2
1st bark: Progressive warning beeps for 1.5 seconds
2nd bark: Progressive warning beeps for 2.5 seconds
3rd bark: Sound for 4 seconds+Vibration for 0.5 seconds
4th bark: Sound for 4 seconds+Vibration for 1 seconds
5th bark: Sound for 4 seconds+Vibration for 1.5 seconds
6th bark: Sound for 4 seconds+Vibration for 2 seconds
7th bark: Sound for 4 seconds+Vibration for 2.5 seconds
8th bark: Sleep Mode for Safety (for 1 minute)
There are total 7 sensitivity levels. The 4th level is set
automatically after installing the battery.
DO NOT PUT THE COLLAR ON YOUR DOG WITHOUT
FIRST TESTING IT UNDER ANY CIRCUMSTANCES.
Make sure you have a good battery before testing.
Operating Instructions:
Our PET681V is almost completely automatic. Just install
a 6 volt alkaline battery, adjust the strap to the size of your
dog's neck and the PET681V automatically begins doing
its job.
3
1. BATTERY INSTALLATION:
1. Remove the decorative cover.
2. Pull the strap loose.
3. Remove the battery cover.
4. Insert the battery (6 volts) between the "clip"[positive
End(+)] and "spring"[negative(-)] contacts.
The collar will be automatically set to the 4th sensitivity
level (total 7 sensitivity levels).
4