Amped Wireless UA600 Setup Manual

SETUP MANUAL
High Power Wireless-300N 600mW USB Adapter
IMPORTANT:
1 Insert the Setup CD
3
Follow the Instructions for your Operating System:
Windows 7 and Vista
A. From the Menu page, select
If the Menu page does not appear, browse the
CD drive and double-click the
C. Continue the Driver Installation
Follow the instructions that appear and click
Install to continue the installation.
E. Insert the High Power USB Adapter
After the computer has fully rebooted, locate two
available USB ports and insert the USB Adapter.
Windows should automatically begin installing the
driver for use with the USB Adapter. If only one
USB port is available, insert the USB connector
labeled Primary.
G. Connect to a Wireless Network
If the network you are trying to connect to has
security enabled you will need to enter it here.
Windows XP and 2000
A. From the Menu page, select
If the Menu page does not appear, browse the
CD drive and double-click the
C. Restart your Computer
A prompt will appear asking you to restart your
computer. Select Yes
E. New Hardware Wizard
When the New Hardware Wizard appears and asks
to search for software, select
Click Next to continue.
G. Connect to a Wireless Network
Amped Wireless
USB Wireless-N Driver
and Utility
Once Windows has completed the software installation
locate the Amped Wireless Utility
open the software by double-clicking the icon. Select
the Available Network
— R E A D
Install Software
Autoload.exe file
Install Software
Autoload.exe file
and click Finish to restart.
No, not this time.
on your desktop and
tab to view nearby networks.
F I R S T
DO NOT INSERT THE USB ADAPTER
UNTIL THE DRIVER HAS BEEN INSTALLED
2 Install Software
The menu page should appear.
Select the instructions for your operating system
below and install the driver for the USB adapter.
Windows Instructions:
Mac Instructions:
Do not insert the USB Adapter until after the
software/driver has been fully installed.
B. Start the Driver Installation
If prompted, click
D. Restart your Computer
A prompt will appear asking you to restart your
computer. Select
F. Connect to a Wireless Network
Locate the Wireless Icon in the Windows System
tray (bottom right-hand corner) and click it to
view available wireless networks. Highlight your
desired network and click Connect.
B. Start the Driver Installation
Click Next
instructions that appear and click
continue.
D. Insert the High Power USB Adapter
After the computer has fully rebooted, locate two
available USB ports and insert the USB Adapter.
The Found New Hardware Wizard should appear.
If only one USB port is available, insert the USB
connector labeled Primary.
F. New Hardware Wizard
When prompted by the New Hardware Wizard to
install the software, select
Automatically
H. Connect to a Wireless Network
Highlight the network that you wish to connect to
and double-click it to connect. If your network
has security enabled, you can enter it in the
Network Key
—
This Side
Back Side
Yes to begin the installation.
Yes and click Finish
to begin the installation. Follow the
Install
Install the Software
(Recommended) and click
field and click OK.
UA600
to restart.
to
Next.