Table of Contents
Advertisement
The push button on the front enables or disables the backsided USB A output. The LED above the push
button lights up when the output is enabled.
"Charging"
- is illuminated when batteries are charged.
- is blinking when battery status is low (20%) - charging is not in progress. If the charging is not started
manually by disabling the output sockets it will start charging automatically when battery status is below
10%
"Mains" green LED is illuminated when the unit is connected to the mains.
Technical specifications Pro-Ject Accu Box S2 USB
Output voltage / current:
Capacity:
Charging time:
External battery charger:
Dimensions W x H x D:
Weight:
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the unit
be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons, release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright
2018. All rights reserved.
©
1x 5V/1A (USB A)
2600 mAh (Li-Pol batteries)
3 hours (outputs disabled)
8.4 V output
103 x 37 x 106 mm
420 g
© Pro-Ject Audio Systems · Pro-Ject Accu Box S2 USB · Revision 2018.08.07
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
3
Advertisement
Table of Contents
Need help?
Do you have a question about the Accu Box S2 USB and is the answer not in the manual?