Table of Contents
Advertisement
When the UV sun monitor is fully charged, it will vibrate once, then flash green in
a slow pattern.
Reset the Device
To reset the EclipseRx, locate the reset button on the bottom of the monitor. Use
a sharp tip to hold down the reset button. Press until you feel the button click.
If the device is off, pressing the reset button will turn the device on. You should
feel a quick vibration.
If the device is on, pressing the button will cause the green LED to flash. If the
you continue to press and hold the button, the green LED will turn off. You must
press the button again for the device to turn back on.
Battery Life and Charging
The EclipseRx is a solar powered wearable - if you're out in the sun, your device
is charging! Your fully charged EclipseRX has a battery life of up to 7 days.
Battery life and charge cycles vary with use and other factors; actual results will
vary.
Finding your current battery level
You can check your battery level on your EclipseRx dashboard
Charging your EclipseRx
A full charge takes approximately an hour and a half.
To charger your UV sun monitor:
1. Plug the charging cable into the USB port on your computer or a UL-
certified USB wall charger.
2. Attach the UV sun monitor to the charger by inserting the charger's pins
into the holes on bottom of the UV sun monitor. You'll know the
connection is secure when the UV sun monitor vibrates, and you see the
indicator lights blinking.
Caring for your EclipseRx
It's important to clean and dry your EclipseRx regularly. Always remember to
keep it clean; keep it dry; don't wear it too tight; and give your wrist a rest.
9 |
P a g e
Advertisement
Table of Contents
