Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Dolphin DOLKSF1000
- Page 1 DOLKSF1000 Dual-relay Access Control V.12.19.17...
-
Page 3: Specifications
INTRODUCTION DOLSKF1000 is the single entry standalone Access Controller with integrated keypad. It is an easy to install and operate device, designs in as less as 6 wires for mounting, with user-friendly programming. The compact design makes it a good choice for door access. DOLSKF1000 is housed in a strong Zinc Alloy electroplated case. -
Page 4: Carton Inventory
Carton Inventory DOLKSF1000 Access Controller Diode 1N4004 (For relay circuit protection) Self Tapping Screws Wall Anchors Screw Driver INSTALLATION > Remove the back cover from the unit > Drill 2 holes(A,C) on the wall for the screws and one hole for the cable >... -
Page 5: Connection Diagram
Wiring Wire Insulation Color Function Notes Request to Exit input(REX) Yellow OPEN 12~24 Votes DC Regulated Power Input Power + Black Ground Normally Open Relay Output Blue Purple Common Connection for Relay Output Orange Normally closed Relay Output Connection Diagram Common power supply: Exit Button Power... - Page 6 Set Master Code The 4-6 digit Master Code is used to prevent unauthorized access to the system. To interface with the DOLKSF1000 the manager will need a Master Code (factory default code: 6666). We highly recommend immediate update and recording of your Master Code.
- Page 7 DOLSKF1000- Simplified Instruction Function Description Operation (Master Code) # Enter the Programming Mode (6666 is the default factory master code) 0 (New Master Code) # (Repeat Change the Master Code New Master Code) # (code: 4-6 digits) 1 (User ID) # (PIN) # The ID number is any number Add PIN User between 0 ~ 999.The PIN is any...
- Page 8 Set Relay Configuration The relay configuration sets the behavior of the output relay on activation. Programming Step Keystroke Combination (Master Code) # 1. Enter Program Mode 4 (1-99) # 2. Pulse Mode The relay time is 1-99 seconds. (1 is 50mS.) Default is 5 seconds. 4 0 # 2.
-
Page 9: General Programming Information
Programming 2 Program PINS Programming will vary depending on the access configuration. Follow the instructions according to your access configuration. GENERAL PROGRAMMING INFORMATION > User ID Number: Assign a user ID number to the access code in order to keep track of the users of access cards or PINS. The user ID number can be any number from 0~999. - Page 10 1. Power the DOLKSF1000 off. 2. Press and hold the * button while power is restored to the DOLKSF1000 3. There's two beeps, and release the button, then one beep. The DOLKSF1000 has been successfully reset.
- Page 12 TRANSMITTER SOLUTIONS WARRANTY The warranty period of Transmitter Solutions keypad is twenty-four (24) months. This warranty shall begin on the date the keypad is manufactured. During the warranty period, the product will be repaired or replaced (at the sole discretion of Transmitter Solutions) if the product does not operate correctly due to a defective component.
Need help?
Do you have a question about the DOLKSF1000 and is the answer not in the manual?
Questions and answers