Advertisement
Quick Links
•
Range 7Mhz - 430Mhz.
•
1/4 wave (50/144MHz), 5/8 wave (144/430MHz)
•
You can also use the antenna as 1/4 wave (144Mhz)
•
To use this antenna properly, read this instruction thoroughly before using it. This antenna (7-430Mhz) is designed
exclusively for amateur radio, communication only.
•
Keep this manual carefully at hand for later use.
Notes for Using the Antenna
To avoid accidents, follow the below notices
1. This antenna is designed to use the car body or the metal handrail as the ground earth when the portable use. Do not
install the antenna fixed and on to the transceiver all the time due to the issues of the product strength and waterproof. This
antenna is prohibited from using for mobile, due to this antenna is not prepared for strong winds.
2. Do not touch the antenna during transmission. Touching the antenna during transmíssion may cause to electrify depending
on the power used.
Description
1. The HF-PRO-1 can be operated on wide band 7-430MHz. lt is OK to use the HF-PRO-1 only when portable operation.
2. If the frecuency adjusted is a higher value, lower the rod element.
3. 144MHz band can be operated at both 1/4 wave and 5/8 wave depending on the lenght of the additional element used.
Specification
Frequency
Max. Power Rating
Impedance
Lenght
Weight
Connector
Type
Accessory
Wide Band Portable Antenna
HF-PRO-1
7-430 MHz Band
130W (SSB)
50 ohms
0.5-1.77m
300gr
PL
1/4 wave reduced type (HF Band). 1/4 wave
(50/144MHz), 5/8 wave (144/430MHz)
*144MHz band can be operated at both 1/4 wave and
5/8 wave by the length of the rod element.
Aditional Elements (Short/Large)
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Komunica HF-PRO-1
Summary of Contents for Komunica HF-PRO-1
- Page 1 • You can also use the antenna as 1/4 wave (144Mhz) • To use this antenna properly, read this instruction thoroughly before using it. This antenna (7-430Mhz) is designed exclusively for amateur radio, communication only. • Keep this manual carefully at hand for later use. Notes for Using the Antenna To avoid accidents, follow the below notices 1. This antenna is designed to use the car body or the metal handrail as the ground earth when the portable use. Do not install the antenna fixed and on to the transceiver all the time due to the issues of the product strength and waterproof. This antenna is prohibited from using for mobile, due to this antenna is not prepared for strong winds. 2. Do not touch the antenna during transmission. Touching the antenna during transmíssion may cause to electrify depending on the power used. Description 1. The HF-PRO-1 can be operated on wide band 7-430MHz. lt is OK to use the HF-PRO-1 only when portable operation. 2. If the frecuency adjusted is a higher value, lower the rod element. 3. 144MHz band can be operated at both 1/4 wave and 5/8 wave depending on the lenght of the additional element used. Specification Frequency 7-430 MHz Band Max. Power Rating 130W (SSB) Impedance 50 ohms Lenght 0.5-1.77m Weight 300gr Connector 1/4 wave reduced type (HF Band). 1/4 wave...
- Page 2 Adjustment (Fig.1) 1. Select the right frecuency, check the position of Settings of HF PRO 1 the antenna body scale with the graphic or the Frequency Scale (mm) band chart Fig.1 & Fig.2 30.000 29.000 2. Loosen the set screw as a half turn by hand. (Keep the rod element retracted). 28.000 24.900 3. Slide the antenna body to the request 21.300 frequency after step 1 and fasten it with the 18.000 set screw by hand. Make the rod element 14.100 full length. 10.500 (Do not use any tools such as pliers when 7.400 Rod Element fasten set screw. The antenna may be Radial Element damaged). (Additional Large/Short) Scale (Fig.2) 4. Transmit and measure the SWR. lf the tuning frequency is lower than the request frequency, make the rod element short or...
Need help?
Do you have a question about the HF-PRO-1 and is the answer not in the manual?
Questions and answers