Advertisement
Fold
CHARGING THE HEADPHONES
be automatically transferred to your
mobile phone. The headphones will
The headphones are equipped with
shut off when AUX/MICRO input is
non-removable built-in battery that can
used, and you will need to unplug and
be charged repeatedly. When used for
power on again for music to play.
the first time, please make sure that the
headphones are fully charged.
LISTENING TO AUDIO
1. Connect the USB charging cable to
1. Press the Power Button once to play
the charging port on the headphones.
music. Press the Power Button
2. Insert the charging cable into the
again to pause the music.
standard power socket. During
2. Short press the Volume "+" button
charging process, the indicator light
one time to go to the previous song
will become red. If the charging has
or beginning of current song. Short
not been started, please unplug the
press the Volume "-" button to go to
charger and then re-insert it.
the next song.
3. After the headphones are fully
3. In the process of playing music or
charged, the red indicator light will
receiving calls, a long press of the
turn off. ln this case, please unplug
Volume "+" or "-" buttons will
the charger from the power socket
increase or decrease the volume
and headphones.
level to desired level.
• Repeated charging and discharging
of the headphones may lead to the
PLAYING MUSIC THROUGH A
declined battery performance over
WIRED CONNECTION
time.
Plug one end of the audio cable
• During charging, please be sure
(included) into your audio device and
not to make or receive phone calls
plug the other end of the cable into the
using the headphones.
headphones' Aux-In port.
NOTE: When the battery capacity
of headphones is not adequate, the
indicator light of headset will flash
red, and you will hear the alarm or
"The headset battery capacity is
low." If the headphones are shut
down during the time when you
make phone calls, these calls will
Fold
Fold
MOBILE PHONE OPERATION
SPECIFICATIONS
When the headphones are paired to
Power Supply: 3.7V, 300mAh
your device and a call is received, the
DC Input: 5V, 1A
incoming call tone will sound.
Range: Class 2, up to 33 ft (10m)
If there is audio playing through the
Driver: 40 mm Dia.
headphones when a call is answered,
Frequency Response: 20Hz~20KHz
the audio will pause and only your call
Sensitivity @ 1KHz: 110 +/- 3 dB
will be audible. When you end the call,
your audio will resume.
Charging Time: Approx. 2 hours
Battery Life: Approx. 14 hours
1. Receiving call: When the bell rings,
short press the Power Button for 1
Compatibility: Bluetooth
second.
device with A2DP/AVRCP/HFP/HSP
2. Hanging up calls: At the end of calls,
short press the Power Button for 1
second.
3. Rejecting calls: When the bell rings,
press and hold the Power Button for
2 seconds.
RESET
To hard reset the headphones, connect
to the USB cable and plug into a
charging source.
CARE AND MAINTENANCE
Do not submerge the headphones in
water. To clean, wipe the headphones
with a soft, dry cloth.
The Bluetooth
are registered trademarks owned of
Bluetooth SIG, Inc. and any use of such
marks by Brookstone is under license.
Fold
®
2.0 or above
word mark and logos
®
Fold
Advertisement
