Advertisement
Quick Links
1.) Into Duplication Mode:
Make sure ""SW" is on "UP" position.
Press and hold all buttons on RRC065A, blue LED flashing 3 times shortly and 3 seconds
later will light on still, now please releasing buttons. It Had into Duplication Mode now.
2.) Duplicating Code:
2-1. Please be sure RRC065A
"SW" has to be on "up" position
RRC065A button still, Blue LED
means that in real Duplication
2-2. Releasing all buttons, and
down position.
2-3. Please take original remote
close to RRC065A right side to
RRC065A red indicator LED
means to the best duplicating position. then press desire button on RRC065A blue LED
will flashing once (It means done), what if blue LED keeping flashing or not light off.(It
means fail), please go back procedure 2-2.
2-4. Push SW1 up.
3.) Finishing Duplicating:
3-1. press all RRC065A together till blue LED flashing once, it means all Done and can be
used.
3-2. What if duplication & set up fail,(Can not remote by RRC065A ),please repeat
procedure 1.) 2.) and 3.) once again.
※ Normally press any RRC065A button, it emits including 4 type Frequency (390MHz /
318MHz / 310MHz / 300MHz) Main receiver will operate in 5 seconds, if you need to
re-emitting signal by RRC065A , Please releasing all buttons after blue LED light' s off and
repress once again.
1.) Following same way with RRC065A Duplication Mode, Duplicating Genie' s
Remote unit code into RRC065A.
2.) Please Following Genie' s Original User Manual, and learning RRC065A as
new group for setting up.
Allremote Wireless Technology, 2006/12/20
RRC065A User Manual
GENIE'S Garage Door operation
had in Duplication Mode.
then press any one of
will keeping flashing.(It
situation)
please push "SW" to the
and press button still also,
find
and
searching
indicating more brighter, It
till
1
Advertisement
Summary of Contents for Allremote Wireless Technology RRC065A
- Page 1 2-2. 2-4. Push SW1 up. 3.) Finishing Duplicating: 3-1. press all RRC065A together till blue LED flashing once, it means all Done and can be used. 3-2. What if duplication & set up fail,(Can not remote by RRC065A ),please repeat procedure 1.) 2.) and 3.) once again.
- Page 2 4.) Every single Genie’s Garage Main receiver only acceptance 2 pcs RRC065A Maximum to learn into on each different remote button. For Example, When you learn into first RRC065A on button A, The second RRC065A must on button B. ※ GENIE’S Main Receiver Learning Mode.
- Page 3 (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Allremote Wireless Technology, 2006/12/20...
Need help?
Do you have a question about the RRC065A and is the answer not in the manual?
Questions and answers