Setting The Unit To Answer The Call; Monitoring An Incoming Call - Panasonic KX-T8100 Operating Instructions Manual

Setting the unit to answer the call
Set the unit as follows to answer calls and to record messages.
1
2
INDIVIDUAL 2WAY MEM
0
MEMO RE
REC
ERASE REC RE
Helpful hints:
Press the ANSWER ON button to turn
on the answering system.
-"Answer set" is heard and the
ANSWER ON indicator light is on.
-The unit is ready to answer the call.
Press the REMAIN REC TIME button to
confirm the remaining recording time.
-The display shows the remaining time
for about 5 seconds.
-If the memory is full, you must erase
some or all messages (page 21 ).
-If you do not want the unit to answer the call, press the ANSWER ON
button to turn off. The ANSWER ON indicator light goes out.
-When the unit receives a call with the memory full, it beeps 6 times,
then hang up. Incoming messages can not be recorded any more.
Monitoring an incoming call
While an incoming call is being recorded, you can monitor it through the
speaker and answer it if you want. You can adjust the volume by using
the VOLUME button.
Helpful hints:
-To answer the call while monitoring, lift up the telephone handset
connected with the same line and talk. The unit stops recording.
-If the unit does not stop recording message, press the hookswitch on
the telephone for about one second, and release it.
-17-