Table of Contents
Advertisement
Quick Links
Your Speedrooter 92R is designed to
give you years of trouble-free, profitable
service. However, no machine is better
than its operator.
Read, understand and follow all safety
warnings and instructions provided with
the product. Failure to follow the warnings
and instructions may result in electric
shock and/or serious injury. Save all warn-
ings and instructions for future reference.
SAVE THESE INSTRUCTIONS!
Speedrooter 92R
Operating Instructions
For 3" through 10"
(75mm—250mm)
®
Pour français voir la page 11
Para ver el español vea la paginá 21
Advertisement
Table of Contents
Summary of Contents for Gap Power Speedrooter 92R
- Page 1 ® Speedrooter 92R Operating Instructions For 3” through 10” (75mm—250mm) Your Speedrooter 92R is designed to give you years of trouble-free, profitable service. However, no machine is better than its operator. Read, understand and follow all safety Pour français voir la page 11 warnings and instructions provided with Para ver el español vea la paginá...
-
Page 2: General Safety Rules
These items could become wrapped around the cable and procedures for the Speedrooter 92R. cause serious injury. This is the safety alert symbol. It is used to alert you to potential personal Always wear safety glasses injury hazards. Obey all safety mes-... -
Page 3: Work Area
® Speedrooter 92R GENERAL SAFETY RULES Personal Safety Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use tool while tired or WARNING under the influence of drugs, alcohol, or medication. A mo- Read and understand all instructions. -
Page 4: Specific Safety Rules
® Speedrooter 92R Ground Fault Circuit Interrupter (GFCI) SPECIFIC SAFETY RULES Your machine is equipped with a ground fault circuit interrupter, which protects you against shock if a short circuit should occur. Check that This is the safety alert symbol. It is used to alert receptacle is properly grounded. -
Page 5: Operation
® Speedrooter 92R Bend the Guide Tube back into the Holder so that it catches a Cutter Application Chart (Table 2) coil near the end of the Guide Tube. (See photo below.) Cutter Cat. # Typical Applications Spear Starting Drill—gets water Head flowing. -
Page 6: Special Operations
® Speedrooter 92R OPERATION 10. Be careful not to let the cutter get caught in the stoppage as you work through it. This can cause kinking and breaking of the ca- Before stepping on the foot pedal, place the guide tube and cable ble. - Page 7 ® Speedrooter 92R Remove the V-Belt. Stand the machine upright, then tighten the retaining bolt with a Turn the drum clockwise with one 3/4” socket with extension. (See Figure 2) hand while pushing the cable into Figure 2 the drum with the other.
-
Page 8: Maintenance
® Speedrooter 92R MAINTENANCE DAMAGED ROLLER Excessive use may wear a roller to the point of failure. It is recom- mended that all three rollers be replaced at the same time (Cat # PO- DISCONNECT MACHINE FROM POWER SOURCE 703). The replacement roller is an assembly consisting of one (1) - Page 9 ® Speedrooter 92R TROUBLE SHOOTING GUIDE (Table 3) Problem Probable Cause Solution Cable kinks or breaks. Operator forcing the cable. Do not force the cable. Let the cutter do the work. Too much slack between machine and Allow no more than two feet between machine and drain.